Command
Show Hosts
Use
This command displays information about the hosts that are configured with the ip hostcommand.
Syntax
Router#show hosts
Example
In the below example we use show hosts to verify the hosts that are configured on R2.
R2#show host Default domain is not set Name/address lookup uses domain service Name servers are 255.255.255.255 Codes: UN – unknown, EX – expired, OK – OK, ?? – revalidate temp – temporary, perm – permanent NA – Not Applicable None – Not defined Host Port Flags Age Type Address(es) R1 None (perm, OK) 0 IP 1.1.1.1 R3 None (perm, OK) 0 IP 3.3.3.3