Month: June 2026

1. Which Cisco feature checks the source IP address of a packet and matches it to the ingress interface on a router to prevent IP spoofing in a network? Loose uRPE Strict uRPF Default uRPE Reverse uRPE 2. Which function is not a function of CoPP? permit packets …

1. Which solution supports the use of overlapping addresses on a PE router? MPLS VRF MP-BGP IPsec VPNs 2. Which command set would create the type of interface that is required for a spoke router in a spoke-to-spoke DMVPN deployment? interface serial 0 and ip unnumbered GigabitEthernet0/0 interface …

1. When an incoming BGP route update is processed on a router, what filtering tool is checked first? Prefix-list Access-list Filter-list Route-map 2. Which BGP verification command displays the BGP table version? show ip bgp neighbors show ip bgp summary show ip route bgp show ip bgp 3. …

1. What feature can be used to optimize the traffic path for a specific application? RSTP uRPF OSPF PBR 2. Refer to the exhibit. After configuring two-way redistribution, an administrator notices that none of the EIGRP routes are being advertised in the OSPF network. What is a possible …

1. What is the OSPF transport? IP/88 IP/89 IP/86 TCP/179 UDP/520 2. What is the OSPF default reference bandwidth? 100 Kbps 100 Mbps 1000 Mbps 10 Mbps 3. What special type of LSA is generated by the ASBR in an OSPF NSSA? Type 3 Type 7 Type 5 …

1. Which transport layer protocol is used for exchange of EIGRP messages? TCP RSVP UDP EIGRP runs directly above the network layer and does not use additional transport protocols. RTP 2. Which of the following would cause the router to go active on a route? The router receives …