Category: CCNA v6
1. By default, what is the OSPF cost for any link with a bandwidth of 100 Mb/s or greater? 100 100000000 1 10000 2. Which command will verify that a router that is running OSPFv3 has formed an adjacency with other routers in its OSPF area? show ipv6 …
1. In which scenario will the use of EIGRP automatic summarization cause inconsistent routing in a network? when the routers in an IPv4 network have mismatching EIGRP AS numbers when the routers in an IPv4 network are connected to discontiguous networks with automatic summarization enabled when there is …
1. Refer to the exhibit. Which two networks contain feasible successors? (Choose two.) 10.44.100.252 10.44.101.252 192.168.71.0 192.168.51.0 10.44.104.253 2. Which three metric weights are set to zero by default when costs in EIGRP are being calculated? (Choose three.) k5 k6 k2 k4 k3 k1 3. What information does …
Refer to the exhibit. What three conclusions can be drawn from the displayed output? (Choose three.) CCNA3 Chapter 5 v5.03 006 The DR can be reached through the GigabitEthernet 0/0 interface. This interface is using the default priority. The BDR has three neighbors. The router ID on the …
1. Refer to the exhibit. Based on the command output shown, what is the status of the EtherChannel? The EtherChannel is dynamic and is using ports Fa0/10 and Fa0/11 as passive ports. The EtherChannel is down as evidenced by the protocol field being empty. The EtherChannel is partially …
The trunk link between two 2960 switches has reached its capacity. How can this be addressed in the most economical way? Increase the speed of the ports. Decrease the size of the inter-switch collision domain by configuring additional VLANs. Combine physical ports into a high-speed logical link by …
1. A switch is participating in a VTP domain and configured as a VTP server. The switch needs to propagate VLAN 10 (used by the Manufacturing department) throughout the VTP domain, but does not have any directly connected hosts using that particular VLAN. Which configuration would satisfy this …
Which two features of enterprise class equipment assists an enterprise network in maintaining 99.999 percent up-time? (Choose two.) failover capabilities collapsed core redundant power supplies failure domains services module Refer to the exhibit. Which devices exist in the failure domain when switch S3 loses power? CCNA3 Chapter 1 …
A router needs to be configured to route within OSPF area 0. Which two commands are required to accomplish this? (Choose two.) RouterA(config)# router ospf 0 RouterA(config)# router ospf 1 RouterA(config-router)# network 192.168.2.0 0.0.0.255 0 RouterA(config-router)# network 192.168.2.0 0.0.0.255 area 0 RouterA(config-router)# network 192.168.2.0 255.255.255.0 0 The computers …
Version 6.0: 1. Refer to the exhibit. Assuming that the routing tables are up to date and no ARP messages are needed, after a packet leaves H1, how many times is the L2 header rewritten in the path to H2? 1 2 3 4 5 6 2. Refer …