Category: CCNA v6
New Version: 1. The buffers for packet processing and the running configuration file are temporarily stored in which type of router memory? flash NVRAM RAM ROM 2. Refer to the exhibit. A company has an internal network of 192.168.10.0/24 for their employee workstations and a DMZ network of …
New Version: 1. Typically, which network device would be used to perform NAT for a corporate environment? DHCP server host device router* server switch 2. Which type of NAT maps a single inside local address to a single inside global address? dynamic static* port address translation overloading 3. …
New Version: 1. Beginning with the Cisco IOS Software Release 15.0, which license is a prerequisite for installing additional technology pack licenses? IPBase UC DATA SEC 2. What is the major release number in the IOS image name c1900-universalk9-mz.SPA.152-3.T.bin? 15 52 2 1900 3 3. Refer to the …
New Version: 1. What is the primary purpose of NAT? conserve IPv4 addresses allow peer-to-peer file sharing enhance network performance increase network security 2. Which method is used by a PAT-enabled router to send incoming packets to the correct inside hosts? It uses the destination TCP or UDP …
New Version: 1. Which DHCPv4 message will a client send to accept an IPv4 address that is offered by a DHCP server? unicast DHCPACK broadcast DHCPACK unicast DHCPREQUEST broadcast DHCPREQUEST 2. A company uses DHCP servers to dynamically assign IPv4 addresses to employee workstations. The address lease duration …
New Version: 1. In which configuration would an outbound ACL placement be preferred over an inbound ACL placement? when the ACL is applied to an outbound interface to filter packets coming from multiple inbound interfaces before the packets exit the interface when a router has more than one …
New Version: 1. What are three primary benefits of using VLANs? (Choose three.) security a reduction in the number of trunk links cost reduction end user satisfaction improved IT staff efficiency no required configuration 2. Which type of VLAN is used to designate which traffic is untagged when …
New Version: 1. Which statement describes the port speed LED on the Cisco Catalyst 2960 switch? If the LED is green, the port is operating at 100 Mb/s. If the LED is off, the port is not operating. If the LED is blinking green, the port is operating …
New Version: 1. A network designer must provide a rationale to a customer for a design which will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.) lower bandwidth requirements …
New Version: 1. Which dynamic routing protocol was developed to interconnect different Internet service providers? BGP EIGRP OSPF RIP 2. Which routing protocol is limited to smaller network implementations because it does not accommodate growth for larger networks? OSPF RIP EIGRP IS-IS 3. What two tasks do dynamic …