CCNPv7 SWITCH Implementing IP Switched Networks course prepares the student with the knowledge and skills necessary to implement scalable multilayer switched networks. This course includes topics on Campus Networks, describing and implementing advanced Spanning Tree concepts, VLANS and Inter-VLAN routing, High Availability, Wireless Client Access, Access Layer Voice concepts, and minimizing service Loss and Data Theft in a Campus Network. This course is recommended preparation for the CISCO CCNP Certification Exam SWITCH.
CCNP SWITCH v7 Labs
Chapter 1 Lab – Preparing the Switch
Lab 3-1 – Static VLANS, Trunking, and VTP
Lab 3-2 – EtherChannel
Lab 4-1 – Implement Spanning Tree Protocols
Lab 4-2 – Multiple Spanning Tree
Lab 5-1 – Inter-VLAN Routing
Lab 5-2 – DHCP
Lab 6-1, First Hop Redundancy Protocols – HSRP and VRRP
Lab 6-2, Hot Standby Router Protocol for IPV6
Lab 6-3, Gateway Load Balancing Protocol (GLBP)
Lab 7-1, Synchronizing Campus Network Devices using Network Time Protocol (NTP)
Lab 7-2 Configure Campus Network Devices to support Simple Network Management Protocol (SNMPv3)
Lab 8-1, IP Service Level Agreements and Remote SPAN in a Campus Environment
Lab 10-1, Securing Layer 2 Switches
Lab 10-2, Securing VLANs
Where is CH1
5-9 please
CCNPv7_SWITCH_CH5_EXAM
Question 1 What is an advantage to using a trunk link to connect a switch to an external router that is providing inter-VLAN routing? works with any switch that supports VLANs and trunking
Question 2
//:0
Refer to the exhibit. The router has been properly configured for the trunking interface. Which statement is true about the routing table on the router? It should contain routes to the 10.10.10.0/24 and the 10.10.11.0/24 networks.
Question 3
//:0
Refer to the exhibit. Which statement is true regarding the diagram and show ip route command output? The default gateway for hosts on VLAN 10 should be the Fa0/0.1 IP address of the router. Refer to curriculum topic: 4.1.2
Question 4
Which two statements are true about routed ports on a multilayer switch? (Choose two.) A routed port is not associated with a particular VLAN. & To create a routed port requires removal of Layer 2 port functionality with the no switchport interface configuration command.
Question 5
Which three statements about a routed port are true? (Choose three.) A routed switch port is created by configuring a Layer 2 port with the no switchport interface configuration command and assigning an IP address. & A routed switch port provides an interface that may provide a Layer 3 connection to a next-hop router. & A routed switch port can serve as a default gateway for devices.
Question 6
//:0
Refer to the exhibit. A network administrator attempts to ping the IP address 172.16.20.1 from RouterA. What will the router output be? Sending 5, 100-byte ICMP Echos to 172.16.20.1, timeout is 2 seconds: …..
Question 7
//:0
Refer to the exhibit and the partial configuration taken on routers RTA and RTB. All users can ping their gateways, but users on VLAN 5 and VLAN 10 cannot communicate with the users on VLAN 20. What should be done to solve the problem? A dynamic routing protocol or static routes should be configured on the routers.
Question 8
//:0
Refer to the exhibit and the partial configuration taken on router RTA. Users on VLAN 5 cannot communicate with the users on VLAN 10. What should be done to fix the problem? The subinterfaces of the router should be configured with 802.1Q encapsulation.
Question 9
//:0
Refer to the exhibit. A network administrator attempts to ping the IP address 172.16.20.1 from RouterA. What will the router output be? Sending 5, 100-byte ICMP Echos to 172.16.20.1, timeout is 2 seconds:…..
Question 10
A client computer is set up for DHCP and needs an IP configuration. During the DHCP client configuration process, which response will enable the client to begin using the assigned address immediately? DHCPACK
Question 11
Which two statements are true about switched virtual interfaces (SVI) on a multilayer switch? (Choose two.) By default, an SVI is created for the default VLAN (VLAN1). & Only one SVI can be associated with a VLAN.
Question 12
//:0
Refer to the exhibit. Which configuration should be applied on router R1 in order for host 1 to receive its IP configuration from the DHCP server?ip helper-address 10.1.1.1 applied to the Fa0/1 interface
Question 13
Which statement describes what occurs when a DHCP request is forwarded through a router that has been configured with the ip helper-address command? The router replaces the broadcast destination IP address of the DHCP request with the unicast IP address that is specified with the ip helper-address command.
Question 14
//:0
Refer to the exhibit. Host A is unable to obtain an IP address from the DHCP server. Which procedure would solve this problem? Use the command ip helper-address 10.1.2.10 on interface Fa0/0 of router RTA.
Question 15
//:0
Refer to the exhibit. What additional configuration is required for host A to receive IP configuration from the DHCP server? The ip helper-address 10.1.2.10 command is required on interface Fa0/0.
Question 16
A client sends a request for an IP address to a DHCP server. Which DHCP message to the client will provide the configuration parameters that include an IP address, a domain name, and a lease for the IP address? DHCPOFFER
Question 17
Which message will be sent back to the client by the DHCP server to confirm that the IP address has been allocated to the client? DHCPACK unicast
Question 18
A DHCPREQUEST message has been sent from the client to the DHCP server. What information is included in the message? formal request for the offered IP address
Question 19
//:0
Refer to the exhibit. Based on the debug ip dhcp server packet output, which statement is true? The client accepts the offer from the DHCP server for the 10.1.10.21 IP address.
Question 20
How is the Layer 2 functionality restored to a port configured for Layer 3 operation? switchport
5-9 please
where is the rest of the chapters an final?
Hello everyone. Can anyone send me CCNP courseware’s link like this: https://static-course-assets.s3.amazonaws.com/ITE6/en/index.html
e-mail: [email protected]
Thanks.
yeah what about the study materials?
hi guy!!!!!! i can see ccnp program that is a good idea. i haven’t seen the study materials for ccnp . are you working on it or what?