CCNP SWITCH Final Test Online (Version 7.1) – Score 100%

Refer to the exhibit. Based on the provided show ip dhcp snooping command, which statement is true?

Refer to the exhibit. Which feature is configured in the displayed output?

What device can be used to support Power over Ethernet (PoE) to power the access points?

Which three actions are taken when the command switchport host is entered on a switch port? (Choose three.)

Which statement is true concerning the core layer within the hierarchical design model?

Which two items in the TCAM table are referenced in the process of forwarding a packet? (Choose two.)

Which three steps are required to configure interfaces as routed ports on a multilayer Catalyst switch? (Choose three.)

Which two statements are true about routed ports on a multilayer switch? (Choose two.)

How many physical links can comprise a single PAgP EtherChannel on a Catalyst 3560 switch? (Choose three.)

What is a characteristic of a standalone WLAN solution?

Which restriction applies to the implementation of FlexLink?

Which multilayer switching forwarding method does Cisco Express Forwarding (CEF) use?

An administrator has noticed that the primary FlexLink link on a switch has shut down and that the standby link is now forwarding traffic. What will happen when the primary link comes back up?

Refer to the exhibit. Switches DSw1 and DSw2 are configured with the HSRP virtual IP address 10.10.10.1, and standby priority is set to 100. Assume both switches finish booting at the same time and HSRP is operating as expected. On the basis of this information, which three HSRP statements are true? (Choose three.)

Refer to the exhibit. What two effects will occur when a fourth distribution module is included in the campus enterprise network that is depicted in the exhibit? (Choose two.)

Which two types of access control lists operate at both Layer 2 and Layer 3 of the OSI model? (Choose two.)

Refer to the exhibit. Given that interface Fa3/42 is an active trunk port, what two conclusions can be made based on the displayed output? (Choose two.)

Refer to the exhibit. A network administrator wants to verify the proper operations of the packet load sharing between a group of redundant routers that are configured with GLBP. On the basis of the provided output, which router is the Active Virtual Forwarder (AVF) for Host2?

When troubleshooting GLBP in an environment with a VLAN that spans multiple access layer switches, a network engineer discovers that suboptimal paths are being used for upstream traffic. What is the recommended solution?

Refer to the exhibit. Assuming that the switch is running Multiple Spanning Tree (MST), which conclusion can be made based on the output?

Which two types of attacks can be mitigated by port security? (Choose two.)

With 802.1X port-based authentication, what are the three specific roles for devices? (Choose three.)

How do Layer 3 switches differ from traditional routers?

Refer to the exhibit. What feature does an SNMP manager need to be able to set a parameter on ACSw1?

Refer to the exhibit. Which STP enhancement should be configured in the network to effectively enforce the position of the root bridge?

Refer to the exhibit. What statement is true about the way HSRP is configured?

Which three actions can cause problems with a VTP implementation? (Choose three.)

Which VTP mode is exclusive to VTP version 3?

Which three statements about RSTP edge ports are true? (Choose three.)

Refer to the exhibit. What is the problem between the connection on Switch1 and Switch2?

What must be understood about the VRRP master when troubleshooting the Virtual Router Redundancy Protocol (VRRP)?

Refer to the exhibit. What happens if interface gigabitEthernet 5/1 on SwitchA stops receiving UDLD packets? (Choose two.)

Refer to the exhibit. What restriction will be presented in a campus enterprise network that is designed with four large distribution building blocks?

Refer to the exhibit. What two conclusions can be made based on the output? (Choose two.)

What are two benefits of local VLANs in the Enterprise Campus Network? (Choose two.)

Refer to the exhibit. The indicated configuration was established on the HSRP standby router RTB. However, the console message %IP-4-DUPADDR started appearing almost immediately on the RTB router. Given the output of the show standby brief command on RTA, what is the cause of the problem?

Which two items are recommended when mapping local VLANs in an Campus Enterprise Architecture? (Choose two.)

Which dhcp option can be configured to ensure that the IP address of the TFTP server is provided to an IP phone?

Refer to the exhibit. What is the result of the displayed configuration on switches ASW1 and ASW2?

When a port security violation occurs on a switch port, the switch sends a syslog message but does not shut down the port. What port security mode is in effect?

What is the most common method of configuring inter-VLAN routing on a Layer 3 switch?

The company’s switch network was updated to use VTP Version 3 for VLANs a week ago, and everything seemed to be working fine. Yesterday you were asked to deploy two new VLANs to support new environmental control systems being installed in the building. You configured VLAN 1433 and VLAN 500 on the primary server and left the port-assignments to junior admins as the systems were installed. Today one of the admins reported that they were unable to assign any interfaces on switch XFL1778 to VLAN 1433, and that the switch was reporting that the VLAN does not exist. After further investigation, they reported that they were able to assign an interface on XFL1778 to VLAN 500 with no issues. What is the most likely problem?

Which STP enhancement should be configured in the network to prevent a nondesignated port to transition to a forwarding state when a topology change occurs?

What three features are provided by IEEE 802.1Q trunking? (Choose three.)

Which three actions are permitted with a VLAN access control list (VACL)? (Choose three.)

A bridging loop occurs in a network and disrupts user connectivity. What action should be taken by a network administrator to restore connectivity?

Refer to the exhibit. What configuration will be required on the DSW switch in order to perform inter-VLAN routing for all VLANs that are configured on the access switches?

Which three parameters must be configured in order to enable SSH? (Choose three.)

Refer to the exhibit. What additional configuration is required in order for users in VLAN 10 to communicate with the users in VLAN 20?

Which two statements are true about the default operation of STP in a Layer 2 switched environment that has redundant connections between switches? (Choose two.)

Which statement correctly explains the process of mitigating ARP attacks on a switch where dynamic ARP inspection (DAI) has been configured?

Which QoS requirement should be taken into account when implementing VoIP in a campus environment?

How should a switch port be configured for a connection to a standalone wireless access point that provides multiple VLAN-separated SSIDs?

Which two procedures should be implemented and in place when deploying VoIP in a campus network? (Choose two.)

What are three possible misconfigurations or indicators of misconfigurations on a Layer 3 interface? (Choose three.)

What type of queuing provides the best quality for voice applications?

Refer to the exhibit. The exhibit contains the configuration for a Cisco access device. How will someone dialing in be authenticated?

What are two actions a hacker may take in a VLAN hopping attack? (Choose two.)

A network administrator wants to implement inter-VLAN routing in the network. Which interfaces should be configured as routed ports?

What is the recommended maximum one-way jitter when implementing video over IP for real-time video applications?

Catalyst Catalyst 6500 switches support which three Supervisor Engine redundancy features? (Choose three.)

Which benefit is provided by centralizing servers in a data center server farm?

Which three issues can cause devices to become disconnected across a trunk link? (Choose three.)

Which architecture enables enterprises to offer important network services, such as security, new communication services, and improved application performance to every office, regardless of its size or proximity to headquarters?

The TCAM defines three different match options that correlate to which three specific match regions? (Choose three.)

How do FlexLink and STP operate together?

When should a proactive management be performed within the stages of the Cisco Lifecycle Services?

What is required for SLA to capture one-way delays?

What is the purpose of the debug condition standby vlan vlan-id group-number command in troubleshooting HSRP?

Which phase of the Cisco Lifecycle Services approach includes building a network according to the design and verifying that it performs according to specifications?

Refer to the exhibit. The link between switch SW1 and SW2 is manually configured as full duplex on SW2 and with half duplex on SW1. How could this impact the STP operations?

What is the most fundamental form of high availability when using Catalyst modular switches?

What is the recommended maximum one-way latency when implementing video over IP for real-time video applications?