IT Exam Items Repository

Which two protocols are link-state routing protocols? (Choose two.)

ITExam Editorial Team asked 6 years ago • CCNA CyberOps

Which two requirements are necessary before a router configured with a link-state routing protocol can build and send its link-state packets? (Choose two.)

ITExamAnswers Editorial Team asked 6 years ago

After a network topology change occurs, which distance vector routing protocol can send an update message directly to a single neighboring router without unnecessarily notifying other routers?

ITExamAnswers Editorial Team asked 6 years ago

Which routing protocol uses link-state information to build a map of the topology for computing the best path to each destination network?

ITExamAnswers Editorial Team asked 6 years ago

Which statement describes a characteristic of the delivery of EIGRP update packets?

ITExamAnswers Editorial Team asked 6 years ago

Which command or commands must be entered on a serial interface of a Cisco router to restore the bandwidth to the default value of that specific router interface?

ITExamAnswers Editorial Team asked 6 years ago

When an EIGRP-enabled router uses a password to accept routes from other EIGRP-enabled routers, which mechanism is used?

ITExamAnswers Editorial Team asked 6 years ago

Fill in the blank. In an EIGRP topology table, a route that is in a/an active state will cause the Diffusing Update Algorithm to send EIGRP queries that ask other routers for a path to this network.

ITExamAnswers Editorial Team asked 6 years ago

Where are EIGRP successor routes stored?

ITExamAnswers Editorial Team asked 6 years ago

Refer to the exhibit. Which command should be used to configure EIGRP to only advertise the network that is attached to the gigabit Ethernet 0/1 interface?

ITExamAnswers Editorial Team asked 6 years ago

Which protocol is used by EIGRP to send hello packets?

ITExamAnswers Editorial Team asked 6 years ago

Refer to the exhibit. Router R3 is receiving multiple routes through the EIGRP routing protocol. Which statement is true about the implementation of summarization in this network?

ITExamAnswers Editorial Team asked 6 years ago

Two routers, R1 and R2, share a 64 kb/s link. An administrator wants to limit the bandwidth used by EIGRP between these two routers to 48 kb/s. Which command is used on both routers to configure the new bandwidth setting?

ITExamAnswers Editorial Team asked 6 years ago

What is the administrative distance of a static route that has been redistributed into EIGRP?

ITExamAnswers Editorial Team asked 6 years ago

Assuming that EIGRP is enabled on both routers and automatic summarization is enabled, what must be configured to ensure that R1 will be able to reach the 2.2.2.0/24 network?

ITExamAnswers Editorial Team asked 6 years ago

« Previous 1…1,198 1,1991,2001,201 1,202…1,378 Next »