IT Exam Items Repository

Refer to the exhibit. What routing solution will allow both PC A and PC B to access the Internet with the minimum amount of router CPU and network bandwidth utilization?
ITExamAnswers Editorial Team asked 7 years ago
Refer to the exhibit. The network engineer for the company that is shown wants to use the primary ISP connection for all external connectivity. The backup ISP connection is used only if the primary ISP connection fails. Which set of commands would accomplish this goal?
ITExamAnswers Editorial Team asked 7 years ago
Open the PT Activity. Perform the tasks in the activity instructions and then answer the question. Which PCs will receive the broadcast sent by PC-C?
ITExamAnswers Editorial Team asked 6 years ago
Fill in the blank. Use the full command syntax. The ” show vlan brief* ” command displays the VLAN assignment for all ports as well as the existing VLANs on the switch.
ITExamAnswers Editorial Team asked 6 years ago
Match the IEEE 802.1Q standard VLAN tag field with the description. (Not all options are used.)
ITExamAnswers Editorial Team asked 7 years ago • 
Refer to the exhibit. A router-on-a-stick configuration was implemented for VLANs 15, 30, and 45, according to the show running-config command output. PCs on VLAN 45 that are using the 172.16.45.0 /24 network are having trouble connecting to PCs on VLAN 30 in the 172.16.30.0 /24 network. Which error is most likely causing this problem?​
ITExamAnswers Editorial Team asked 7 years ago • 
A high school uses VLAN15 for the laboratory network and VLAN30 for the faculty network. What is required to enable communication between these two VLANs while using the router-on-a-stick approach?
ITExamAnswers Editorial Team asked 7 years ago • 
Refer to the exhibit. A network administrator needs to configure router-on-a-stick for the networks that are shown. How many subinterfaces will have to be created on the router if each VLAN that is shown is to be routed and each VLAN has its own subinterface?
ITExamAnswers Editorial Team asked 7 years ago • 
Refer to the exhibit. In what switch mode should port G0/1 be assigned if Cisco best practices are being used?
ITExamAnswers Editorial Team asked 7 years ago • 
Refer to the exhibit. Router RA receives a packet with a source address of 192.168.1.35 and a destination address of 192.168.1.85. What will the router do with this packet?
ITExamAnswers Editorial Team asked 6 years ago
Which four steps are needed to configure a voice VLAN on a switch port? (Choose four).
ITExamAnswers Editorial Team asked 7 years ago • 
What is a characteristic of legacy inter-VLAN routing?
ITExamAnswers Editorial Team asked 6 years ago
Refer to the exhibit. DLS1 is connected to another switch, DLS2, via a trunk link. A host that is connected to DLS1 is not able to communicate to a host that is connected to DLS2, even though they are both in VLAN 99. Which command should be added to Fa0/1 on DLS1 to correct the problem?
ITExam Editorial Team asked 6 years ago
Which command is used to remove only VLAN 20 from a switch?
ITExamAnswers Editorial Team asked 6 years ago
Port Fa0/11 on a switch is assigned to VLAN 30. If the command no switchport access vlan 30 is entered on the Fa0/11 interface, what will happen?
ITExamAnswers Editorial Team asked 7 years ago • 
« Previous1…1,3201,3211,3221,3231,324…1,378Next »