IT Exam Items Repository

In which two types of areas will the ABR forward LSA 3s into an area? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • 
Which two statements are true abut interarea and intraarea routes in multiarea OSPF? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • 
In an OSPF hubandspoke topology, what needs to be done to ensure that the spoke routers would never be selected as DR and BDR? All spoke routers need to be configured with an OSPF interface priority of 0 (ip ospf priority) so that they will not become the DR/BDR.* All routers must be configured with an OSPF interface priority of 0 (ip ospf priority) to disable the DR/BDR election process. Because nonbroadcast networks do not elect a DR/BDR, nothing needs to be done. One of the spoke routers will need to be configured as the DR by setting the OSPF interface priority higher than 1 (ip ospf priority).
ITExamAnswers Editorial Team asked 4 years ago • 
What does OSPF use to reduce the number of exchanges of routing information in networks where large numbers of neighbors are present? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • ,
A network administrator is planning an OSPF implementation and must ensure proper router DR/BDR assignments. What is the default interface priority value for OSPF routers?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. What does the state “FULL/ -” indicate?
ITExamAnswers Editorial Team asked 4 years ago • ,
Refer to the diagram. Which state is RTB in if it sees itself in the RTA hello but no routing information has been exchanged?
ITExamAnswers Editorial Team asked 4 years ago • 
For OSPF, which three options must be the same within the hello packet that is exchanged between two adjacent routers? (Choose three.)
ITExamAnswers Editorial Team asked 4 years ago • 
Which two statements are true about multiarea OSPF? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • 
What does the Cisco IOS use to calculate the OSPF cost to a destination network?
ITExamAnswers Editorial Team asked 4 years ago • 
Which of the following statements are correct regarding named EIGRP configuration? (Choose three.)
ITExamAnswers Editorial Team asked 4 years ago • 
Which statement is not correct regarding named EIGRP configuration?
ITExamAnswers Editorial Team asked 4 years ago • 
Router R1's GigabitEthernet 0/0 is configured with the IPv6 address 2001:DB8:CAFE:1::1/64. Which of the following would enable EIGRP for IPv6, with an AS of 1, on this interface?
ITExamAnswers Editorial Team asked 4 years ago • 
Which type of EIGRP packet is sent when the active time is only half way through to help overcome any SIA issue?
ITExamAnswers Editorial Team asked 4 years ago • 
Which EIGRP stub options would be used on a router to advertise only directly connected networks that are enabled for EIGRP?
ITExamAnswers Editorial Team asked 4 years ago • 
« Previous1…503504505506507…1,378Next »
Ask Question