1. What type of device routes traffic destined to network segments beyond the source network segment for which the sending node may not have explicit routing information? virtual router standby router default gateway Layer 3 switch 2. What device presents the illusion of a single router to hosts …

1. Which three DHCPv6 roles can a router perform? (Choose all that apply.) DHCPv6 client DHCPv6 relay agent DHCPv6 server 2. Which command is not configured in stateless DHCPv6? address prefix ipv6-address/prefix domain-name name dns-server server-address ipv6 dhcp server pool-name 3. An IPv6-enabled router is to acquire its …

1. What destination UDP port do DHCPv6 clients use to send DHCPv6 messages? 67 68 547 546 2. What DHCPv6 message does a host send to look for a DHCPv6 server? ADVERTISE SOLICIT INFORMATION-REQUEST REQUEST 3. What DHCPv6 message does a host send to the DHCPv6 server if …

1. Which two ICMPv6 messages are used in the SLAAC process? (Choose two.) Neighbor Advertisements (NA) Neighbor Solicitation (NS) Router Solicitation (RS) Router Advertisements (RA) 2. Which command must be configured on a router to enable it to join the IPv6 all-routers multicast address ff02::2? ip routing ipv6 …

1. Which address type is automatically created by default on a host interface when no RAs are received? global unicast address link-local address MAC address 2. Which method best describes stateless DHCP? SLAAC only SLAAC with stateless DHCPv6 Server Stateful DHCPv6 Server

1. Which message is sent by a DHCPv4 client to initiate the lease obtaining process? DHCPDISCOVER DCHPOFFER DHCPREQUEST DHCPACK 2. Which two DHCPv4 messages are sent by the server in the lease obtaining process? (Choose two.) DHCPDISCOVER DCHPOFFER DHCPREQUEST DHCPACK 3. Which two DHCPv4 messages are used in …

1. Which are benefits of EtherChannel technology? (Choose all that apply.) fault-tolerance load sharing increased bandwidth link redundancy 2. True or False? FastEthernet and GigabitEthernet links can be combined into a single EtherChannel. True False 3. True or False? PAgP and LACP are both Cisco-proprietary link aggregation protocols. …

1. Which three STP port states are merged into the RSTP discarding port state? (Choose three.) disabled blocking listening learning forwarding 2. Which protocol was designed to bring faster convergence to STP? PortFast RSTP PVST MSTP 3. Which technology solves the problem of a device being unable to …

1. By default (without any configuration on a switch), what will determine which switch is the root bridge? The bridge priority The extended system ID The MAC address of the switch The bridge ID 2. The root bridge will be the switch with the: Lowest bridge ID Highest …

1. Which statement describes STP? STP is a Layer 2 routing protocol. STP is a Layer 3 routing protocol for Ethernet LANs. STP is a Layer 2 loop prevention protocol for Ethernet LANs. STP is a Layer 3 loop prevention protocol for IP networks. 2. Without STP on …