Assessment ESwitching Chapter 5 – CCNA 3 Exploration: LAN Switching and Wireless (Version 4.0) 1. Which two criteria does a switch use to select the root bridge? (Choose two.) bridge priority switching speed number of ports base MAC address switch location memory size 2. Which two statements are …

Assessment ESwitching Chapter 4 – CCNA 3 Exploration: LAN Switching and Wireless (Version 4.0) 1. Refer to the exhibit. S2 was previously used in a lab environment and has been added to the production network in server mode. The lab and production networks use the same VTP domain …

Assessment ESwitching Chapter 3 – CCNA 3 Exploration: LAN Switching and Wireless (Version 4.0) 1. Refer to the exhibit. The network administrator has just added VLAN 50 to Switch1 and Switch2 and assigned hosts on the IP addresses of the VLAN in the 10.1.50.0/24 subnet range. Computer A …

Assessment ESwitching Chapter 2 – CCNA 3 Exploration: LAN Switching and Wireless (Version 4.0) 1. Refer to the exhibit. Which hosts will receive a broadcast frame sent from Host A? hosts A and B hosts B and C hosts D and E hosts A, B, and C hosts …

Assessment ESwitching Chapter 1 – CCNA 3 Exploration: LAN Switching and Wireless (Version 4.0) 1. Refer to the exhibit. What characteristic of hierarchical network designs is exhibited by having SW3 connected to both SW1 and Sw2? scalability security redundancy maintainability 2. Which two characteristics are associated with enterprise …

Step 1: Config Router R1. Router> enRouter# conf tRouter(config)# hostname R1 config)# no ip domain-lookup config)#int lo0 config-if)#ip addr 192.168.1.1 255.255.255.0 config-if)#exit config)#int s0/1 config-if)#ip addr 192.168.2.1 255.255.255.0 config-if)#clock rate 64000 ← DCE config-if)#no shut config-if)#exit Step 2: configuration on Router R2. Router> en Router# conf tRouter(config)# hostname …

Redistribute EIGRP RIP OSPF 1. Configuration interface of router. *Configuration On R1 – Configuration rename device Router>enable Router#configure terminal Router(config)#hostname R1 R1(config)# – Configuration Banner motd R1(config)#banner motd “itexamanswers” – Configuration console R1(config)#line console 0 R1(config-line)#password cisco R1(config-line)#loggin synchronous R1(config-line)#exit – Configuration telnet R1(config)#line vty 0 4 R1(config-line)#password …

Learning ObjectivesUpon completion of this lab, you will be able to:• Cable a network according to the Topology Diagram.• Erase the startup configuration and reload a router to the default state.• Perform basic configuration tasks on a router.• Configure and activate Ethernet interfaces.• Test and verify configurations.• Reflect …

Assessment ERouting Final – CCNA 2 Exploration: Routing Protocols and Concepts (Version 4.0) 1. Refer to the exhibit. The network consists of hundreds of routers branched from connected regional distribution sites using single area OSPF. Recent network failures caused packet flooding and route recalculations in all branch networks. …

Learning Objectives:  Upon completion of this lab, you will be able to:  • Cable devices and establish console connections.  • Erase and reload the routers.  • Perform basic IOS command line interface operations.  • Perform basic router configuration.  • Verify and test configurations using show commands, ping and …