Command
Privilege
Use
Sets the privilege level you run at upon logging in through the console.
Syntax
Router(config-line)#privilege level <0-15>
Example
In this example, privilege level 15 is used to set the console privilege to enable mode upon login.
R2#conf t Enter configuration commands, one per line. End with CNTL/Z. R2(config)#line con 0 R2(config-line)#privilege level 15
The running config for the console port is shown with privilege level set to 15.
R2(config-line)#do show run | sec con Building configuration… Current configuration : 1424 bytes control-plane line con 0 exec-timeout 15 50 privilege level 15 logging synchronous