Switchport Mode Access Command on CISCO Router/Switch

Apr 25, 2018 Last Updated: Apr 25, 2019 CCNA Study Guide No Comments
Tweet Share Pin it

Command

Switchport Mode Access

Use

Sets interface to access mode.

Syntax

Switch(config-if)#switchport mode access

Example

In this example int fa0/2 is set to access mode on SW4.

SW2#conf t
Enter configuration commands, one per line. End with CNTL/Z.
SW2(config)#int fa0/2
SW2(config-if)#switchport mode access
Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments
0
Would love your thoughts, please comment.x
()
x