IP Bandwidth-Percent Command on CISCO Router/Switch

Command

IP Bandwidth-Percent

Use

This command is used to change how much bandwidth the EIGRP routing process can use on a link. By default EIGRP can use up to 40% of the bandwidth.
This is for EIGRP operational traffic, such as queries or hellos.

Syntax

Router(config-if)#ip bandwidth-percent eigrp <AS> <percent>

Example

In this example, we will limit the EIGRP process on R2’s Fa0/0 interface to only use 20% of the link.

R2(config-if)#ip bandwidth-percent eigrp 100 20

Related Articles

Leave a Reply

avatar