IT Exam Items Repository

A network administrator is configuring an EtherChannel link between switches SW1 and SW2 by using the command SW1(config-if-range)# channel-group 1 mode passive. Which command must be used on SW2 to enable this EtherChannel?

ITExamAnswers Editorial Team asked 6 years ago

Refer to the exhibit. A network administrator has decided that an EtherChannel between ports 0/1 and 0/2 on switches S1 and S2 would help performance. After making the configuration, the administrator notices no performance gain. Based on the output that is shown, what two possible assumptions could a network administrator make? (Choose two.)

ITExamAnswers Editorial Team asked 6 years ago

Which command must be used on SW2 to enable this EtherChannel?

ITExamAnswers Editorial Team asked 6 years ago

Which two protocols are used to implement EtherChannel? (Choose two.)

ITExamAnswers Editorial Team asked 6 years ago

What is a best practice to use before beginning an EtherChannel implementation?

ITExamAnswers Editorial Team asked 6 years ago

Fill in the blank. In FHRP operation, two or more routers are represented as a single virtual router.

ITExamAnswers Editorial Team asked 6 years ago

Refer to the exhibit. A network engineer is troubleshooting host connectivity on a LAN that uses a first hop redundancy protocol. Which IPv4 gateway address should be configured on the host?

ITExamAnswers Editorial Team asked 7 years ago

Launch PT Hide and Save PT. Open the PT Activity. Perform the tasks in the activity instructions and then answer the question. What are two reasons why the ping messages that are issued from Laptop0 towards Laptop1 are failing? (Choose two.)

ITExamAnswers Editorial Team asked 6 years ago

Match the description to the correct command. (Not all options are used.)

ITExamAnswers Editorial Team asked 6 years ago

The trunk link between two 2960 switches has reached its capacity. How can this be addressed in the most economical way?

ITExamAnswers Editorial Team asked 6 years ago

Which command will initiate EtherChannel interface configuration mode?

ITExamAnswers Editorial Team asked 6 years ago

Which PAgP mode combination will establish an EtherChannel?

ITExamAnswers Editorial Team asked 6 years ago

What is an advantage of using LACP?

ITExamAnswers Editorial Team asked 6 years ago

Which statement describes an EtherChannel implementation?

ITExamAnswers Editorial Team asked 7 years ago

What is the most cost-effective method of solving interface congestion that is caused by a high level of traffic between two switches?

ITExamAnswers Editorial Team asked 6 years ago

« Previous 1…1,203 1,2041,2051,206 1,207…1,378 Next »