IT Exam Items Repository

Refer to the exhibit. A network technician is performing an initial installation of a new switch in the east wing. The technician removes the switch from the box, connects the switch to a router that supports the 10.255.254.0/24 network, and adds the configuration that is shown. The technician notifies the network administrator that the switch has been installed. The network administrator then attempts to telnet to the switch from host 192.168.0.1 to complete the switch configuration. What are the results of this attempt to telnet?
ITExamAnswers Editorial Team asked 3 years ago • 
After an administrator installs a WIC into a two-slot router and issues the show version command, the newly installed interfaces in the WIC cannot be seen in the router output. What is a possible reason why the newly installed interfaces are not displayed in the router output?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. Two network engineers are setting up a prototype network to test a new Frame Relay network design. One of the engineers connects the cables and powers up all of the devices per the test plan. The second engineer uses a console cable to connect to the BR1 router, configures the Frame Relay connection and issues a show interfaces serial 2/0 command. What does the output of this command indicate to the engineers?
ITExamAnswers Editorial Team asked 3 years ago • 
An engineer who is part of a sales team has been asked to select technologies and equipment capabilities to meet the network requirements of the prospective client. The engineer is also responsible for diagramming the placement and interconnection of various network devices and services. Which role is this engineer performing?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. A NetworkingCompany designer is reviewing a diagram of a customer network. What two risks or issues can be identified in the topology that is shown? (Choose two.)
ITExamAnswers Editorial Team asked 3 years ago • 
A new host needs to be connected to VLAN 1. Router RA is attached to the VTP trunk and configured as shown in the output contained in the graphic. Which of the following IP addresses should be assigned to this new host?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. A pre-sales system engineer receives a diagram of the current WAN from a customer. EIGRP is the routing protocol that is used on the WAN. Based on the default operation of EIGRP, which statement is true about the routing table on router RE?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. A NOC technician at an ISP enters the command shown. What are two reasons to use this command? (Choose two.)
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. The network administrator needs to configure the Fa0/0 interface of RTB so that hosts from RTA can connect to the server that is attached to RTB. Which two commands will the administrator use to accomplish this task? (Choose two.)
ITExamAnswers Editorial Team asked 3 years ago • 
The command copy tftp running-config has been entered on the router. What will this command do?
ITExamAnswers Editorial Team asked 3 years ago • 
A small tire retailer requires a low-cost WAN connection to its headquarters in order to manage its inventory and process customer sales in real time. Which WAN connection type is best suited to its needs?
ITExamAnswers Editorial Team asked 3 years ago • 
In an IPv4 environment, what information is used by the router to forward data packets from one interface of a router to another?
ITExamAnswers Editorial Team asked 4 years ago • ,
How many host addresses may be assigned on each subnetwork when using the 130.68.0.0 network address with a subnet mask of 255.255.248.0?
ITExamAnswers Editorial Team asked 4 years ago • ,
A hacker attempts to reach confidential information that is stored on a server inside the corporate network. A network security solution inspects the entire packet, determines that it is a threat, and blocks the packet from entering the inside network. Which security measure protected the network?
ITExamAnswers Editorial Team asked 3 years ago • 
What are two purposes of DNS? (Choose two.)
ITExamAnswers Editorial Team asked 3 years ago • 
« Previous1…256257258259260…1,378Next »
Ask Question