IT Exam Items Repository Refer to the exhibit. R1 is connected to the Internet through its serial 0/0/0 interface. Hosts on the 192.168.100.0/24 LAN on R1 cannot communicate with hosts on the Internet. What two NAT configuration issues might explain this failure? (Choose two.)ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Refer to the exhibit. A network administrator enters the command ip route 10.10.4.16 255.255.255.248 s0/0/1 into the router. What will be the result of this configuration?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Refer to the exhibit. A network support technician has been asked to set an IP address on one of the FastEthernet interfaces on a new router. What is causing the interface to reject the address?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Which three statements are true about RSTP? (Choose three.)ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Refer to the exhibit. Assuming that all three routers are configured with the EIGRP routing protocol and sharing information, what information can be gathered from the show command output?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4What two statements are true regarding EIGRP tables? (Choose two.)ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Refer to the exhibit. In what sequence (from first to last) does an OSPF router check the parameters listed when selecting the DR?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Refer to the exhibit. A network administrator wishes to deny Internet access to all R2 LAN hosts, while allowing these hosts to reach all other devices on the company networks. Where the ACL shown in the exhibit should be placed to meet these requirements?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4What do companies gain from the services performed at the enterprise edge?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Refer to the exhibit. RIPv2 is configured in the network shown. Hosts in the network have access to all internal networks but do not have Internet access. On which router should the commands, shown in the exhibit, be added to provide Internet access for all hosts in the network?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4What is the term for the value 2172416 that is highlighted in the output of the show ip eigrp topology command?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4A company is using a Class B IP addressing scheme and expects to need as many as 150 networks. What is the correct subnet mask to use with the network configuration?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Which two criteria are used by STP to select a root bridge? (Choose two.)ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Refer to the exhibit. Because of continuing instability of one of the serial links in the OSPF network, a network administrator configures router ASBR as shown. Which two statements will be a result of this configuration? (Choose two.)ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Refer to the exhibit. A network administrator noticed that the VLAN configuration changes at SW2 did not propagate to SW3. On the basis of the partial output of the show vtp status command, what is the possible cause of the problem?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4