IT Exam Items Repository

A network administrator uses the RIP routing protocol to implement routing within an autonomous system. What are two characteristics of this protocol? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. All routers are properly configured to use the EIGRP routing protocol with default settings, and the network is fully converged. Which statement correctly describes the path that the traffic will use from the 10.1.1.0/24 network to the 10.1.2.0/24 network?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. Both routers are using the RIP protocol. Devices on the 192.168.1.1 network can ping the S0/0/0 interface on R2 but cannot ping devices on the 192.168.2.1 network. What is a possible cause of this problem?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. The routers are properly configured using a dynamic routing protocol with default settings, and the network is fully converged. Router A is forwarding data to router E. Which statement is true about the routing path?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. The show cdp neighbors command was run at R1. Which two facts about the newly detected device can be determined from the output? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. To implement the RIPv2 protocol, the network administrator runs the commands as displayed. However, the show ip protocol command fails to display any output. How can the administrator solve the problem that is indicated by the lack of output from this command?
ITExamAnswers Editorial Team asked 4 years ago • 
A network is configured with the IP, IPX, and AppleTalk protocols. Which routing protocol is recommended for this network?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. What action will R2 take for a packet that is destined for 192.168.2.0?
ITExamAnswers Editorial Team asked 4 years ago • 
Which two statements are true regarding link-state routing protocols? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • 
When a router boots, what is the default order to locate the Cisco IOS if there is no boot system command?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. All router interfaces are configured with an IP address and are operational. If no routing protocols or static routes are configured, what information will be included in the show ip route command output for router A?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. Which router is advertising subnet 172.16.1.32/28?
ITExamAnswers Editorial Team asked 4 years ago • 
What is the function of the OSPF LSR packet?
ITExam Editorial Team asked 6 years ago • ,
Which two components are used to determine the router ID in the configuration of the OSPF routing process? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • 
What are two tasks that must be completed before two routers can use OSPF to form a neighbor adjacency? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • 
« Previous1…738739740741742…1,378Next »
Ask Question