IT Questions Bank

IT Questions Bank 1

Which three statements characterize UDP? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 5 years ago • 
Refer to the exhibit. What will router R1 do with a packet that has a destination IPv6 address of 2001:db8:cafe:5::1?
IT Questions Bank 2ITExamAnswers asked 5 years ago • 
How will a router handle static routing differently if Cisco Express Forwarding is disabled?
IT Questions Bank 2ITExamAnswers asked 5 years ago • 
Refer to the exhibit. A network technician issues the command show vlan to verify the VLAN configuration. Based on the output, which port should be assigned with native VLAN?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which two things should a network administrator modify on a router to perform password recovery? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A network administrator has been allocated the IPv4 10.10.240.0/20 block of addresses for a LAN. Two devices on two different, but contiguous, subnets on the LAN have been assigned the addresses 10.10.247.1/21 and 10.10.248.10/24, respectively. The administrator has to create a third subnet from the remaining address range. To optimize the use of this address space, the new subnet will follow on directly from the existing subnets. What is the first available host address in the next available subnet
IT Questions Bank 7IT Administrator asked 3 years ago • 
Refer to the exhibit. A network administrator issues the show lldp neighbors command to display information about neighboring devices. What can be determined based on the information?
IT Questions Bank 7IT Administrator asked 4 years ago • 
What is defined by the ip nat pool command when configuring dynamic NAT?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which address type is not supported by IPv6
IT Questions Bank 7IT Administrator asked 3 years ago • 
Which ACE would permit traffic from hosts only on the 192.168.8.0/22 subnet?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which two issues might cause excessive runt and giant frames in an Ethernet network? (Choose two.)
IT Questions Bank 7IT Administrator asked 3 years ago • 
Refer to the exhibit. Which static route would an IT technician enter to create a backup route to the 172.16.1.0 network that is only used if the primary RIP learned route fails?
IT Questions Bank 2ITExamAnswers asked 5 years ago • 
Refer to the exhibit. Which three events will occur as a result of the configuration shown on R1? (Choose three.)
IT Questions Bank 7IT Administrator asked 3 years ago • 
A network technician is configuring port security on a LAN switch interface. The security policy requires host MAC addresses to be learned dynamically, stored in the address table, and saved to the switch running configuration. Which command does the technician need to add to the following configuration to implement this policy?
IT Questions Bank 7IT Administrator asked 3 years ago • 
A network administrator is using the router-on-a-stick model to configure a switch and a router for inter-VLAN routing. What configuration should be made on the switch port that connects to the router?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
« Previous1…960961962963964…1,320Next »
Ask Question