Month: January 2023
CCNA 4 v6.0 (Connecting Networks v6) Chapter 4: Access Control Lists: Check Your Understanding Questions Answers 1. Which three statements describe ACL processing of packets? (Choose three.) A packet can either be rejected or forwarded as directed by the ACE that is matched. A packet that does not …
CCNA 4 v6.0 (Connecting Networks v6) Chapter 3: Branch Connections: Check Your Understanding Questions Answers 1. Which technology provides a secure connection between a SOHO and the headquarters office? PPPoE QoS VPN WiMax 2. Which two network components does a teleworker require to connect remotely and securely from …
CCNA 4 v6.0 (Connecting Networks v6) Chapter 2: Point-to-Point Connections: Check Your Understanding Questions Answers 1. Which command can be used to view the cable type that is attached to a serial interface? Router(config)# show interfaces Router(config)# show controllers Router(config)# show ip interface Router(config)# show ip interface brief …
CCNA 4 v6.0 (Connecting Networks v6) Chapter 1: WAN Concepts: Check Your Understanding Questions Answers 1. A small company with 10 employees uses a single LAN to share information between computers. Which type of connection to the Internet would be appropriate for this company? A broadband service, such …
CCNA 3 v6.0 (Scaling Networks v6) Chapter 10: OSPF Tuning and Troubleshooting: Check Your Understanding Questions Answers 1. What information can be gathered from the routing table entry O*E2 0.0.0.0/0 via 192.168.16.3, 00:20:22, Serial0/0/0? The edge of the OSPF area 0 is the interface that is addressed 192.168.16.3. …
CCNA 3 v6.0 (Scaling Networks v6) Chapter 9: Multiarea OSPF: Check Your Understanding Questions Answers 1. Which statement describes a multiarea OSPF network? It consists of multiple network areas that are daisy-chained together. It has a core backbone area, with other areas connected to the backbone area. It …
CCNA 3 v6.0 (Scaling Networks v6) Chapter 8: Single-Area OSPF: Check Your Understanding Questions Answers 1. A router is participating in an OSPFv2 domain. What will always happen if the dead interval expires before the router receives a Hello packet from an adjacent DROTHER OSPF router? A new …
CCNA 3 v6.0 (Scaling Networks v6) Chapter 7: EIGRP Tuning and Troubleshooting: Check Your Understanding Questions Answers 1. What is the purpose of a Null0 route in the routing table? To act as a gateway of last resort To prevent routing loops when summarizing routes To prevent the …
CCNA 3 v6.0 (Scaling Networks v6) Chapter 6: EIGRP: Check Your Understanding Questions Answers 1. What is the purpose of using protocol-dependent modules in EIGRP? To accommodate routing of different network layer protocols To describe different routing processes To identify different application layer protocols To use different transport …
CCNA 3 v6.0 (Scaling Networks v6) Chapter 5: Dynamic Routing: Check Your Understanding Questions Answers 1. Which dynamic routing protocol was developed to interconnect different Internet service providers? BGP EIGRP OSPF RIP 2. Which routing protocol is limited to smaller network implementations because it does not accommodate growth …
