8.2.2.7 Packet Tracer - Configuring OSPFv2 in a Single Area Instructions Answers

Packet Tracer Configuring OSPFv2 in a Single Area (Instructor Version)

Instructor Note: Red font color or Gray highlights indicate text that appears in the instructor copy only.

Topology

8.2.2.7 Packet Tracer - Configuring OSPFv2 in a Single Area Instructions Answers 1

Addressing Table

8.2.2.7 Packet Tracer - Configuring OSPFv2 in a Single Area Instructions Answers 2

Objectives

Part 1: Configure OSPFv2 Routing

Part 2: Verify the Configurations

Background

In this activity, the IP addressing is already configured. You are responsible for configuring the three router topology with basic single area OSPFv2 and then verifying connectivity between end devices.

Note: The topology is the same one used in the chapter examples. In addition, the student practiced the configuration of this topology in the Syntax Checker activities. Therefore, the student should be able to complete this activity with minimal assistance.

Part 1: Configure OSPFv2 Routing

Step 1: Configure OSPF on the R1, R2 and R3.

Use the following requirements to configure OSPF routing on all three routers:

– Process ID 10
– Router ID for each router: R1 = 1.1.1.1; R2 = 2.2.2.2; R3 = 3.3.3.3
– Network address for each interface
– LAN interface set to passive (do not use the default keyword)

Step 2: Verify OSPF routing is operational.

On each router, the routing table should now have a route to every network in the topology.

Part 2: Verify the Configurations

Each PC should be able to ping the other two PCs. If not, check your configurations.

!--------------------------
!R1
!--------------------------
ena
conf t
!
router ospf 10
 router-id 1.1.1.1
 network 172.16.1.0 0.0.0.255 area 0
 network 172.16.3.0 0.0.0.3 area 0
 network 192.168.10.4 0.0.0.3 area 0
 passive-interface GigabitEthernet0/0
!
en

!--------------------------
!R2
!--------------------------
ena
conf t
!
router ospf 10
 router-id 2.2.2.2
 network 172.16.2.0 0.0.0.255 area 0
 network 172.16.3.0 0.0.0.3 area 0
 network 192.168.10.8 0.0.0.3 area 0
 passive-interface GigabitEthernet0/0
!
end

!--------------------------
!R3
!--------------------------
ena
conf t
!
router ospf 10
 router-id 3.3.3.3
 network 192.168.1.0 0.0.0.255 area 0
 network 192.168.10.4 0.0.0.3 area 0
 network 192.168.10.8 0.0.0.3 area 0
 passive-interface GigabitEthernet0/0
!
end

Download Packet Tracer (.pka) file:

8.2.2.7 Packet Tracer - Configuring OSPFv2 in a Single Area.pka 116.81 KB 4118 downloads

...

Download