Time limit: 0
Quiz-summary
0 of 20 questions completed
Questions:
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
Information
CCNP ROUTE Chapter 2 Test Online (Version 7) – Score 100%
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
Results
0 of 20 questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 points, (0)
Average score |
|
Your score |
|
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- Answered
- Review
-
Question 1 of 20
1. Question
1 pointsWhich EIGRP algorithm tracks all the routes that are advertised by neighbors and uses the composite metric of each route to compare the routes?Correct
Incorrect
-
Question 2 of 20
2. Question
1 pointsIf an EIGRP route goes down and a feasible successor is not found in the topology table, how does DUAL flag the route that has failed?Correct
Incorrect
-
Question 3 of 20
3. Question
1 pointsRefer to the exhibit. EIGRP has been configured on all routers in the topology. Given the sample exhibited metric values, which path will be selected by the DUAL algorithm as a successor route and feasible successor route or routes for traffic that travels from router A to E?Correct
Incorrect
-
Question 4 of 20
4. Question
1 pointsRefer to the exhibit. All three routers are exchanging EIGRP routes. What value represents the advertised distance of the feasible successor for the 10.1.2.0/24 network?Correct
Incorrect
-
Question 5 of 20
5. Question
1 pointsRefer to the exhibit. What is the advertised distance of the feasible successor to network 192.168.1.0?Correct
Incorrect
-
Question 6 of 20
6. Question
1 pointsThe network administrator wants RTA to send only the summarized route of 10.10.0.0/16 to RTB. Which configuration will accomplish this?Correct
Incorrect
-
Question 7 of 20
7. Question
1 pointsRefer to the exhibit. Based on the output of show ip eigrp neighbors, what are two possible problems with adjacencies between Router1 and Router2? (Choose two.)Correct
Incorrect
-
Question 8 of 20
8. Question
1 pointsWhich statement is a requirement for the EIGRP AS number?Correct
Incorrect
-
Question 9 of 20
9. Question
1 pointsWhat should be done to examine EIGRP adjacency information including uptime and hold time?Correct
Incorrect
-
Question 10 of 20
10. Question
1 pointsWhich two solutions are used in an EIGRP network to reduce DUAL computations? (Choose two.)Correct
Incorrect
-
Question 11 of 20
11. Question
1 pointsWhen does an EIGRP router place a route in the active state?Correct
Incorrect
-
Question 12 of 20
12. Question
1 pointsIf replies are not received from all outstanding queries, how long will an EIGRP router wait before placing a route into the SIA state?Correct
Incorrect
-
Question 13 of 20
13. Question
1 pointsRefer to the exhibit. An administrator has configured routers R1 and R2 for EIGRP IPv6 as shown. After completing the configurations and verifying that the interfaces are up, the administrator notes that the routers have not formed an EIGRP adjacency. What needs to be done to allow the neighboring routers to establish adjacency?Correct
Incorrect
-
Question 14 of 20
14. Question
1 pointsWhich EIGRP feature limits Query message scope in a network to improve network stability and reducing resource utilization?Correct
Incorrect
-
Question 15 of 20
15. Question
1 pointsWhich EIGRP stub options would be used on a router to advertise only directly connected networks that are enabled for EIGRP?Correct
Incorrect
-
Question 16 of 20
16. Question
1 pointsWhich type of EIGRP packet is sent when the active time is only half way through to help overcome any SIA issue?Correct
Incorrect
-
Question 17 of 20
17. Question
1 pointsWhen implementing EIGRP unequal cost load balancing using the variance command, which two conditions must be met? (Choose two.)Correct
Incorrect
-
Question 18 of 20
18. Question
1 pointsRouter R1’s GigabitEthernet 0/0 is configured with the IPv6 address 2001:DB8:CAFE:1::1/64. Which of the following would enable EIGRP for IPv6, with an AS of 1, on this interface?Correct
Incorrect
-
Question 19 of 20
19. Question
1 pointsWhich statement is not correct regarding named EIGRP configuration?Correct
Incorrect
-
Question 20 of 20
20. Question
1 pointsWhich of the following statements are correct regarding named EIGRP configuration? (Choose three.)Correct
Incorrect