IT Exam Items Repository

Refer to the exhibit. A network administrator is configuring BGP on the router RT1. Which command set will allow RT1 to establish a neighbor relationship with RT2?
ITExam Editorial Team asked 6 years ago • 
Which routing protocol is used to exchange routing information between autonomous systems on the Internet?
ITExamAnswers Editorial Team asked 6 years ago • 
Which transport layer port is used in BGP peering?
ITExamAnswers Editorial Team asked 6 years ago • 
Refer to the exhibit. An administrator applies the configurations to routers R1 and R2 respectively. Both routers use the FastEthernet0/0 interface to connect to the same Ethernet switch. However, a neighbor adjacency fails to form. What is a possible cause for the problem?
ITExamAnswers Editorial Team asked 5 years ago • 
Which OSPF LSA type provides information about IPv6 address prefixes associated with a transit network by referencing a network LSA?
ITExamAnswers Editorial Team asked 5 years ago • 
A network administrator has enabled single-area OSPFv3 on a router via the ipv6 router ospf 100 command. Which command will enable this OSPFv3 process on an interface of that router?​
ITExamAnswers Editorial Team asked 5 years ago • 
Which command will verify that a router running OSPFv3 has received a redistributed default static route from another OSPFv3 router?
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. What type of OSPF router is HQ-3?
ITExamAnswers Editorial Team asked 5 years ago • 
An administrator is troubleshooting an OSPFv3 network and wants to view the PID, the RID, the reference bandwidth, and the area parameters for both IPv4 and IPv6 address families. Which single command can be used to display the information?
ITExamAnswers Editorial Team asked 5 years ago • 
An administrator is troubleshooting OSPFv3 adjacency issues. Which command would the administrator use to confirm that OSPFv3 hello and dead intervals are matching between routers?​
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. Which would be chosen as the router ID of R2?
ITExamAnswers Editorial Team asked 6 years ago • ,
What is the IPv6 address used by OSPFv3 non-DR/BDR routers to send link-state updates and link-state acknowledgments?
ITExamAnswers Editorial Team asked 6 years ago • 
What IPv6 address does an OSPFv3 router use as the source address for OSPFv3 packets exchanged with OSPFv3 neighbors?
ITExamAnswers Editorial Team asked 6 years ago • 
Which command should a network technician issue on a Cisco router to display status information about OSPFv3 IPv6 address family neighbor routers?
ITExamAnswers Editorial Team asked 5 years ago • 
Which LSA type is generated by all OSPFv3 routers to describe the state and cost of interfaces in an area?
ITExamAnswers Editorial Team asked 6 years ago • 
« Previous1…1,0321,0331,0341,0351,036…1,378Next »