IT Exam Items Repository

What is described by the interarea prefix LSAs sent by an OSPFv3 ABR?
ITExamAnswers Editorial Team asked 6 years ago • 
A network technician is configuring OSPFv3 with address families on a Cisco router. To verify the configuration the technician issues the show ospfv3 interface brief command. Which three items of information would the technician expect to be displayed? (Choose three.)
ITExamAnswers Editorial Team asked 6 years ago • 
What are two features of OSPFv3? (Choose two.)
ITExamAnswers Editorial Team asked 6 years ago • 
Which OSPFv3 LSA type is used by ASBRs to announce routes learned through redistribution from other routing protocols?
ITExam Editorial Team asked 6 years ago • 
Refer to the exhibit. A network administrator has configured OSPFv2 on the two Cisco routers but PC1 is unable to connect to PC2. What is the most likely problem?
ITExamAnswers Editorial Team asked 7 years ago • 
Refer to the exhibit. A company uses OSPF as its internal routing protocol. No routing protocol is used between the company and the ISP. The network administrator enters the following command on the router that connects to the ISP.
ITExamAnswers Editorial Team asked 6 years ago • 
Refer to the exhibit. Why are routers R1 and R2 not able to establish an OSPF adjacency?​
ITExamAnswers Editorial Team asked 7 years ago • ,
A network engineer new to a company notices that a particular Layer 3 device participating in routing OSPF networks has an interface the engineer has not seen before in the output of the show ip ospf interface brief command. The interface is listed as VL0 and has a state of P2P with an OSPF neighbor. Which OSPF feature is the company using?
ITExamAnswers Editorial Team asked 6 years ago • 
Which OSPF router or routers would require the following command to define a stub area?
ITExamAnswers Editorial Team asked 6 years ago • 
Refer to the exhibit. OSPF is used in the network. Which path will be chosen by OSPF to send data packets from Net A to Net B?
ITExamAnswers Editorial Team asked 6 years ago • 
In which two situations would an OSPF point-to-multipoint configuration be used? (Choose two.)
ITExamAnswers Editorial Team asked 6 years ago • 
Refer to the exhibit. Which three statements describe the results of the OSPF election process of the topology that is shown in the exhibit? (Choose three.)
ITExamAnswers Editorial Team asked 7 years ago • 
Which two commands will configure OSPFv2 MD5 authentication on a router interface? (Choose two.)
ITExamAnswers Editorial Team asked 6 years ago • 
An administrator is troubleshooting a router in a mixed EIGRPv4 and EIGRPv6 network. Which command can be used to see if the split horizon rule has been applied to an interface for the IPv6 address family?
ITExamAnswers Editorial Team asked 6 years ago • 
An administrator is troubleshooting connectivity between two routers configured with EIGRPv6. The routing table, for both the respective routers, displays all the advertised networks and the authentication parameters for key ID and the key string match. Unfortunately, authentication fails between the two routers. What is a possible cause?
ITExamAnswers Editorial Team asked 6 years ago • 
« Previous1…1,0671,0681,0691,0701,071…1,378Next »