IT Exam Items Repository

Which three statements describe the weight attribute for BGP? (Choose three.)
ITExam Editorial Team asked 6 years ago • 
A network administrator is configuring a BGP router with the neighbor 10.12.1.2 maximum-prefix 10 command. What will happen when the peer at 10.12.1.2 advertises more than 10 routes?
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. A network administrator is troubleshooting BGP configuration and wants to display only routes with AS 300 being the first AS in the AS_Path value. Which regular expression should the administrator use in the command show bgp ipv4 unicast regex regex-pattern ?
ITExam Editorial Team asked 6 years ago • 
A network administrator is configuring route summarization for received routes before advertising to the next peer with the commands:
ITExamAnswers Editorial Team asked 5 years ago • 
Which type of BGP peer templates define configuration settings specifically for the address family policy?
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. A network administrator is configuring BGP route filtering on R1. The objective is to advertise only locally originated routes to its neighbor to avoid undesirable transit connectivity. Which AS path ACL should the administrator configure?
ITExam Editorial Team asked 6 years ago • 
Refer to the exhibit. Given the above configuration commands, which two statements are true? (Choose two.)
ITExam Editorial Team asked 6 years ago • 
A large company is deploying network connectivity to multiple ISP sites. What are two considerations for running IBGP on internal routers compared with redistributing a BGP table into an IGP? (Choose two.)
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. A network administrator is configuring BGP on a router. What network layer protocol and function are enabled for the BGP session?
ITExam Editorial Team asked 6 years ago • 
Refer to the exhibit. Which two configurations will allow router R1 to establish a neighbor relationship with router R2? (Choose two.)
ITExamAnswers Editorial Team asked 6 years ago • ,
Match the values to AFI and SAFI extensions supported by MBGP. (Not all options are used.)
ITExam Editorial Team asked 6 years ago • 
Which command is used to enable OSPFv3 and address families on an interface?
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. A network administrator is configuring OSPF for R1 and R2, but the adjacency cannot be established. What is the cause of the issue?
ITExamAnswers Editorial Team asked 6 years ago • 
An administrator attempts to change the router ID on a router that is running OSPFv3 by changing the IPv4 address on the router loopback interface. Once the IPv4 address is changed, the administrator notes that the router ID did not change. What two actions can the administrator take so that the router will use the new IPv4 address as the router ID? (Choose two.)
ITExamAnswers Editorial Team asked 6 years ago • 
Under which configuration mode are OSPFv3 summarization commands issued?
ITExamAnswers Editorial Team asked 6 years ago • 
« Previous1…1,0661,0671,0681,0691,070…1,378Next »