IT Exam Items Repository In which functional area of the Cisco Enterprise Architecture should IDS and IPS be located to detect and prevent services from accessing hosts?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4What can be found at the enterprise edge? ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4What will a router do with a packet that is destined for a host with the IP address 192.168.1.5/24 if no entry for the 192.168.24.0/24 network exists in the routing table?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4The network administrator can ping a remote router but is unable to telnet to it. At what layer of the OSI model does this error occur?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Which two services are required to enable a computer to receive dynamic IP addresses and access the Internet using domain names? (Choose two.)ITExamAnswers Editorial Team asked 6 years ago • CCNA Discovery v4Refer to the exhibit. A network administrator is troubleshooting the serial connection between R1 and R2. There is no communication between R1 and R2. Based on the output of the show ip interface brief command, what is the cause of the problem?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Refer to the exhibit. There is no dynamic routing protocol that is running on this network. The network administrator adds a static route via the use of the ip route 192.168.4.0 255.255.255.0 10.1.1.6 command. On which router should the network administrator issue this command?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Refer to the exhibit. The interfaces on R1 and R2 have been properly configured with the IP addresses as shown. No dynamic routing protocols have been configured. The network administrator has entered the commands that are shown in the exhibit. Which two additional commands need to be entered on the routers to enable host A to access the Internet? (Choose two.)ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4What is the function of the forward lookup DNS zone in the DNS name resolution process?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4What is the basis for determining the vector component of a route in the distance vector routing algorithm?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4If the start-up configuration is not found in NVRAM, where will the router look for it next by default?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Refer to the exhibit. The network administrator has added networks A and B to router R1. Which two subnetwork numbers should be used to address networks A and B so that these networks use the same subnet mask as networks C and D? (Choose two.)ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4A building has experienced a power outage. When the power returns, none of the devices on one floor can access the Internet. The network administrator checks the switch in the IDF that these devices are connected to and notes that the SYST LED on the front of the switch is amber. What is a possible cause of this problem?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4will occur if connectivity with the other host isITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4Refer to the exhibit. The network administrator uses the command below to configure a default route on RTB: RTB(config)# ip route 0.0.0.0 0.0.0.0 fa0/0 A ping issued from PC3 is successful to RTB. However, echo request packets arrive at PC1 but the echo replies do not make it back to PC3. What will fix this problem?ITExamAnswers Editorial Team asked 3 years ago • CCNA Discovery v4