IT Exam Items Repository

Refer to the exhibit. Router R1 currently is configured to use R3 as the primary route to the Internet, and the route uses the default administrative distance settings. A network engineer must configure R1 so that it uses R2 as a backup, but only if R3 goes down. Which command must the engineer configure on R1 so that it correctly uses R2 as a backup route, without changing the administrative distance configuration on the link to R3?
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. Which minimum configuration items are needed to enable Secure Shell version 2 access to R15?
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. Which action must be taken to ensure that router A is elected as the DR for OSPF area 0?
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. R1 learns all routes via OSPF Which command configures a backup static route on R1 to reach the 192.168.20.0/24 network via R3?
ITExamAnswers Editorial Team asked 5 years ago • 
A network engineer is configuring a switch so that it is remotely reachable via SSH. The engineer has already configured the host name on the router. Which additional command must the engineer configure before entering the command to generate the RSA key?
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. Users on existing VLAN 100 can reach sites on the Internet. Which action must the administrator take to establish connectivity to the Internet for users in VLAN 200?
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. Which command configures OSPF on the point-to-point link between routers R1 and R2?
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. Which switch becomes the root of a spanning tree for VLAN 20 if all links are of equal speed?
ITExamAnswers Editorial Team asked 5 years ago • 
Which two network actions occur within the data plane? (Choose two.)
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. Which command must be issued lo enable a floating static default route on router A?
ITExamAnswers Editorial Team asked 5 years ago • 
Refer to the exhibit. Drag and drop the prefix lengths from the left onto the corresponding prefixes on the right Not all prefixes are used see the answer below.
ITExamAnswers Editorial Team asked 5 years ago • 
Drag and drop the TCP or UDP details from the left onto their corresponding protocols on the right.
ITExamAnswers Editorial Team asked 5 years ago • 
Drag and drop the Rapid PVST+ forwarding slate actions from the loft to the right. Not all actions are used.
ITExamAnswers Editorial Team asked 5 years ago • 
Drag the descriptions of device management from the left onto the types of device management on the right.
ITExamAnswers Editorial Team asked 6 years ago
Refer to the exhibit. An engineer has started to configure replacement switch SW1. To verify part of the configuration, the engineer issued the commands as shown and noticed that the entry for PC2 is missing. Which change must be applied to SW1 so that PC1 and PC2 communicate normally?
ITExamAnswers Editorial Team asked 5 years ago • 
« Previous1…931932933934935…1,378Next »