Refer to the topology below and answer the following questions. Note: There may be different faults in this sim so please notice the following faults: 1. ACL blocking traffic on interface between R2 and R3 2. The network was not advertised in EIGRP 3. Two routers couldn’t establish …
Question Refer to the topology TUT Company recently installed a new router in their office. Complete the network installation by performing the initial router configurations and configuring RIPv2 routing using the router command line interface (CLI) on the R2-TUT. Name of the router is R2-TUT Enable-secret password is cisco1 The …
Your company has just added R3 router to the existing network. But currently no routing updates are being exchanged between R3 and the network. All other connectivity, including Internet access are working properly. The task is to identify the fault(s) and correct the router configuration to provide full …
Question You are tasked to configure Internet access on a router. The ISP has provided the company six public IP addresses of 198.18.184.105 198.18.184.110. The company has 14 hosts that need to access the internet simultaneously. The hosts in the company LAN have been assigned private space addresses …
An administrator is trying to ping and telnet from Switch to Router with the results shown below: Switch> Switch> ping 10.4.4.3 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.4.4.3,timeout is 2 seconds: .U.U.U Success rate is 0 percent (0/5) Switch> Switch> telnet 10.4.4.3 Trying …
Question Security is being added to the Corp1 router. The user on host C should be able to use a web browser to access financial information from the Finance Web Server. No other hosts from the LAN nor the Core should be able to use a web browser …
Refer to the topology below, you are only allowed to access the CLI of Sw-AC3 to answer some questions. This does not require any configuration. What interface did Sw-AC3 associate with source MAC address 0010.5a0c.ffba ? a) Fa0/1 b) Fa0/3 c) Fa0/6 d) Fa0/8 * e) Fa0/9 f) …
The topology below is running OSPF. You are required to troubleshoot and resolve the OSPF issues between the various routers. Use the appropriate show commands to troubleshoot the issues. Instead of posting the output of “show run” commands we post here the commands entered on each router to …
Refer to the topology. Your company has connected the routers R1, R2 and R3 with serial links. R2 and R3 are connected to the switches SW1 and SW2, respectively. SW1 and SW2 are also connected to the routers R4 and R5. The EIGRP routing protocol is configured. You …
Refer to the topology below and answer the questions. Examine the DHCP configuration between R2 and R3, R2 is configured as the DHCP server and R3 as the client. What is the reason R3 is not receiving the IP address via DHCP? A. On R3, DHCP is not …