Which function of the IP SLAs ICMP jitter operation can you use to determine whether a VoIP issue is caused by excessive end-to-end time? A. round-trip time latency B. packet loss C. jitter D. successive packet loss Which statement about the IP SLAs ICMP Echo operation is true? …

Which command can you enter to verify that a BGP connection to a remote device is established? A. show ip bgp summary B. show ip community-list C. show ip bgp paths D. show ip route Which two components are used to identify a neighbor in a BGP configuration? …

A network administrator is troubleshooting an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval and the queue counts for the adjacent routers also need to be checked. What command will display …

What routing protocol use first-hand information from peers? A. link state B. distance-vector C. path-vector D. other Which prefix does OSPFv3 use when multiple IPv6 address are configured on a single interface? A. all prefix on the interface B. the prefix that the administrator configure for OSPFv3 use …

Which three statements about link-state routing are true? (Choose three) A. It uses split horizon. B. Updates are sent to a broadcast address. C. RIP is a link-state protocol. D. Updates are sent to a multicast address by default. E. Routes are updated when a change in topology …

How to configure RIPv2? (Choose two) A. Enable RIP B. Connect RIP to WAN interface C. Enable auto-summary D. Enable authentication Which two options are requirements for configuring RIPv2 for IPv4 (Choose two)? A. enabling RIP authentication B. connecting RIP to a WAN Interface C. enabling auto route …

Refer to the exhibit. All of the routers in the network are configured with the ip subnet-zero command. Which network addresses should be used for Link A and Network A? (Choose two) A. Network A – 172.16.3.48/26 B. Network A – 172.16.3.128/25 C. Network A – 172.16.3.192/26 D. …

Which two statements about floating static routes are true? (Choose two) A. They are routes to the exact /32 destination address B. They are used when a route to the destination network is missing C. They have a higher administrative distance than the default static route administrative distance …

Which value is indicated by the next hop in a routing table? A. preference of the route source B. IP address of the remote router for forwarding the packets C. how the route was learned D. exit interface IP address for forwarding the packets Which component of the …

A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of …