IT Questions Bank

IT Questions Bank 1

Which algorithm does the EIGRP routing protocol use?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. What does the value 2816 represent in the output display?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
When are EIGRP update packets sent?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Where should EIGRP summarization be applied?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which multicast address does an EIGRP-enabled router use to send query packets?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which table is used by EIGRP to store all routes that are learned from EIGRP neighbors?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which static path would be the primary default path out of the network?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Consider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 What does the 5 at the end of the command signify?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A network administrator is configuring an EtherChannel trunk link to add additional allowed VLANs to pass the link. Which statement describes the process of this change?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is the maximum bandwidth of a T1 point-to-point connection?
IT Questions Bank 11IT Administrator asked 4 years ago • 
In which link aggregation mode does an interface initiate EtherChannel negotiation by sending LACP packets?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which three parameters must match, on the ports of two switches, for a PAgP Etherchannel to be created? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
When EtherChannel is configured, which mode will force an interface into a port channel without exchanging aggregation protocol packets?
IT Questions Bank 2ITExamAnswers asked 5 years ago • 
Which technology is an open protocol standard that allows switches to automatically bundle physical ports into a single logical link?
IT Questions Bank 2ITExamAnswers asked 5 years ago • 
etwork administrator must enable DHCP services between two sites. What must be configured for the router to pass DHCPDISCOVER messages on to the server?
IT Questions Bank 11IT Administrator asked 4 years ago • 
« Previous1…1,0211,0221,0231,0241,025…1,320Next »
Ask Question