IT Questions Bank Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?ITExamAnswers asked 4 years agoRefer to the exhibit. Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the output from RouterA, what are two possible reasons for the failure? (Choose two.)ITExamAnswers asked 4 years agoRefer to the exhibit. A network administrator attempts to ping Host2 from Host1 and receives the results that are shown. What is the problem?ITExamAnswers asked 4 years agoRefer to the exhibit. The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem? (Choose three.)ITExamAnswers asked 4 years agoRefer to the exhibit. HostA cannot ping HostB. Assuming routing is properly configured, what is the cause of this problem?ITExamAnswers asked 4 years agoRefer to the exhibit. A problem with network connectivity has been observed. It is suspected that the cable connected to switch port Fa0/9 on Switch1 is disconnected. What would be an effect of this cable being disconnected?ITExamAnswers asked 4 years agoThe network shown in the diagram is experiencing connectivity problems. Which of the following will correct the problems? (Choose two.)ITExamAnswers asked 4 years agoIn which circumstance are multiple copies of the same unicast frame likely to be transmitted in a switched LAN?ITExamAnswers asked 4 years agoHost 1 is trying to communicate with Host 2. The e0 interface on Router C is down. Which of the following are true? (Choose two.)ITExamAnswers asked 4 years agoRefer to the exhibit. Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network. The network administrator connected to router Coffee via the console port, issued the show ip route command, and was able to ping the server. Based on the output of the show ip route command and the topology shown in the graphic, what is the cause of the failure?ITExamAnswers asked 4 years agoRefer to the exhibit. What is the meaning of the output MTU 1500 bytes?ITExamAnswers asked 4 years agoWhich of these represents an IPv6 link-local address?ITExamAnswers asked 4 years agoWhich command can you use to manually assign a static IPv6 address to a router interface?ITExamAnswers asked 4 years agoWhich IPv6 address is valid?ITExamAnswers asked 4 years agoRefer to the exhibit. Which address range efficiently summarizes the routing table of the addresses for router Main?ITExamAnswers asked 4 years ago