IT Questions Bank Which access control component, implementation, or protocol indicates success or failure of a client-requested service with a PASS or FAIL message?IT Administrator asked 4 years agoThe address pool of a DHCP server is configured with 10.7.30.0/24. The network administrator reserves 5 IP addresses for printers. How many IP addresses are left in the pool to be assigned to other hosts?IT Administrator asked 4 years agoWhich access control component, implementation, or protocol logs EXEC and configuration commands configured by a user?ITExamAnswers asked 4 years agoMatch the steps with the actions that are involved when an internal host with IP address 192.168.10.10 attempts to send a packet to and external server at the IP address 209.165.200.254 across a router R1 that running dynamic NAT. (Not all options are used.)IT Administrator asked 4 years agoWhich access control component, implementation, or protocol controls who is permitted to access a network?ITExamAnswers asked 4 years agoAn administrator is configuring single-area OSPF on a router. One of the networks that must be advertised is 198.19.0.0 255.255.252.0. What wildcard mask would the administrator use in the OSPF network statement?IT Administrator asked 4 years agoWhich three OSPF states are involved when two routers are forming an adjacency? (Choose three.)IT Administrator asked 4 years agoWhat type of traffic is described as traffic that requires at least 30 Kbps of bandwidth?IT Administrator asked 4 years agoA network manager wants to determine the size of the Cisco IOS image file on the networking device. What command should the administrator use on a Cisco router?IT Administrator asked 4 years agoA network technician is attempting to configure an interface by entering the following command: SanJose(config)# ip address 192.168.2.1 255.255.255.0 . The command is rejected by the device. What is the reason for this?IT Administrator asked 4 years agoA network administrator has configured an EtherChannel between two switches that are connected via four trunk links. If the physical interface for one of the trunk links changes to a down state, what happens to the EtherChannel?ITExamAnswers asked 4 years agoWhich two channel group modes would place an interface in a negotiating state using PAgP? (Choose two.)ITExamAnswers asked 4 years agoWhich port role is assigned to the switch port that has the lowest cost to reach the root bridge?ITExamAnswers asked 4 years agoWhat is a characteristic of spanning tree?ITExamAnswers asked 4 years agoWhat is the function of STP in a scalable network?ITExamAnswers asked 4 years ago