IT Questions Bank

IT Questions Bank 1

Which command is used to enable LLDP globally on a Cisco IOS ISR?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which keyword in a NAT configuration enables the use of one outside IP address for multiple inside hosts?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Refer to the exhibit. Which VLAN ID is associated with the default VLAN in the given environment?
IT Questions Bank 2ITExamAnswers asked 4 years ago
What is the destination MAC address of a broadcast frame?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Refer to the exhibit. How will switch SW2 handle traffic from VLAN 10 on SW1?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which unified access point mode continues to serve wireless clients after losing connectivity to the Cisco Wireless LAN Controller?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Refer to the exhibit. How will the router handle a packet destined for 192.0.2.156?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which effete does the aaa new-model configuration command have?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Refer to the exhibit. Which command would you use to configure a static route on Router1 to network 192.168.202.0/24 with a nondefault administrative distance?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Refer to the exhibit. After you apply the given configuration to arouter, the DHCP clients behind the device connot communicate with hosts outside of their subnet. Which action is most likely to correct the problem?
IT Questions Bank 2ITExamAnswers asked 4 years ago
A. The designated port B. The backup port C. The alternate port D. The root port
IT Questions Bank 2ITExamAnswers asked 4 years ago
You are configuring your edge routers interface with a public IP address for Internet connectivity. The router needs to obtain the IP address from the service provider dynamically. Which command is needed on interface FastEthernet 0/0 to accomplish this?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which configuration command can u apply to a HSRP router so that its local interface becomes active if all other routers in the group fail?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which type of VPN uses the public key infrastructure and digital certificates?
IT Questions Bank 15IT Administrator asked 4 years ago
What type of address is 10.131.48.7?
IT Questions Bank 15IT Administrator asked 4 years ago
« Previous1…1,2801,2811,2821,2831,284…1,316Next »
Ask Question