IT Questions Bank

IT Questions Bank 1

Refer to the exhibit. Why did R1 and R2 not establish an adjacency?
IT Questions Bank 2ITExamAnswers asked 4 years ago • , ,
What characterizes an EIGRP stub site feature?
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Which capability is supported by all three DMVPN phase models?
IT Questions Bank 2ITExamAnswers asked 3 years ago • ,
What is the reason for a network engineer to alter the default reference bandwidth parameter when configuring OSPF?
IT Questions Bank 2ITExamAnswers asked 4 years ago • , ,
Consider the following access list that allows IP phone configuration file transfers from a particular host to a TFTP server: R1(config)# access-list 105 permit udp host 10.0.70.23 host 10.0.54.5 range 1024 5000 R1(config)# access-list 105 deny ip any any R1(config)# interface gi0/0 R1(config-if)# ip access-group 105 out Which method would allow the network administrator to modify the ACL and include FTP transfers from any source IP address?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A network administrator is troubleshooting an issue with a DMVPN tunnel. From the output of the show dmvpn command, the administrator notes that the tunnel is in the IPsec state. What problem does this state indicate?
IT Questions Bank 7IT Administrator asked 3 years ago • 
Which forwarding address is used by OSPFv3 address families learned routes to forward data packets to the next hop router?
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Refer to the exhibit. Router R2 is configured for 2-way redistribution between OSPF and EIGRP. When the network administrator views the EIGRP topology table on R1, no redistributed routes from OSPF are present. What corrective action on R2 should the administrator take to resolve this issue?
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Which two network prefixes match the prefix match pattern 172.16.0.0/12 ge 16? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Refer to the exhibit. Which protocol is used by R2 and R5 to exchange Layer 3 routes?
IT Questions Bank 7IT Administrator asked 3 years ago • 
Refer to the exhibit. A network administrator issues the show bgp ipv4 unicast 10.1.1.128 command on router R2 to verify the network 10.1.1.128 in the BGP table. The administrator notices that there are two paths to reach the network. Which BGP factor is used to determine the best-path?
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
A network technician is verifying the OPSFv3 address families configuration on a Cisco router. What would the technician expect to see displayed when the show ospfv3 database router adv-router 4.4.4.4 command is issued?
IT Questions Bank 7IT Administrator asked 3 years ago • 
Refer to the exhibit. Routers R1 and R2 were configured with EIGRP message authentication, but the routers cannot exchange EIGRP messages. Which two problems are causing the EIGRP authentication failure between R1 and R2 in this configuration? (Choose two.)
IT Questions Bank 7IT Administrator asked 3 years ago • 
Which is a characteristic of policy based routing (PBR)?
IT Questions Bank 7IT Administrator asked 3 years ago • 
Refer to the exhibit. A user has configured a NIC on the PC as shown but finds that the PC is unable to access the Internet. What is the problem?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
« Previous1…376377378379380…1,320Next »
Ask Question