IT Questions Bank When using the netstat -r command on a host, you see a route 0.0.0.0 0.0.0.0.0. What does this route represent?ITExamAnswers asked 2 years ago • CCNA 1 v6The ip default-gateway command was not used when configuring a switch. How will this affect network communication? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 1 v6What are the required steps for configuring an interface on a router? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 1 v6During the boot process of a Cisco router, you notice a series of hash symbols (#) appearing on the terminal emulator screen from the console session. In what phase is the boot process?ITExamAnswers asked 2 years ago • CCNA 1 v6In what part of a router is the current configuration being used located?ITExamAnswers asked 2 years ago • CCNA 1 v6When configuring a host, the gateway was not configured. How will this affect communication to and from this device?ITExamAnswers asked 2 years ago • CCNA 1 v6On a router, what field in an IPv4 header should be examined to determine that the maximum number of hops have been reached by the packet on its way from the source to this destination?ITExamAnswers asked 2 years ago • CCNA 1 v6Why was IPv4 designed as a connectionless protocol?ITExamAnswers asked 2 years ago • CCNA 1 v6Which of the following is associated with the network layer?ITExamAnswers asked 2 years ago • CCNA 1 v6Which layer of the OSI model is concerned with end-to-end communication over the network?ITExamAnswers asked 2 years ago • CCNA 1 v6Fill in the blanks. To configure a routed port, the interface must be put into Layer 3 mode by using the ____ interface configuration command. After this, the interface must be assigned an ____ address.ITExamAnswers asked 2 years ago • CCNA 1 v6What name is given to a physical port on a Layer 3 switch configured to act as a router port?ITExamAnswers asked 2 years ago • CCNA 1 v6What type of switching is used on current L2 switches to allow QoS?ITExamAnswers asked 2 years ago • CCNA 1 v6Fill in the blanks. The MAC address table is sometimes referred to as a ____ table because it is stored in ____ memory.ITExamAnswers asked 2 years ago • CCNA 1 v6Fill in the blanks. When a switch receives a broadcast frame, it enters the source information in its ____ and then it ____ the frame to all ports except the one the frame was ____ on.ITExamAnswers asked 2 years ago • CCNA 1 v6