IT Questions Bank In the following example, you forgot to enter an ACE to deny the user at IP address 192.168.10.10. Which command would correctly enter the ACE to filter this address?ITExamAnswers asked 2 years ago • CCNA 3 v7A network administrator is writing a standard ACL to deny any traffic from the 10.10.0.0/16 network but permit all other traffic. Which two commands should be used? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v7A network administrator needs to configure a standard ACL so that only the workstation of the administrator with the IP address 10.1.1.10 can access the virtual terminal of the main router. Which two configuration commands can achieve the task? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v7In the second ACE shown in the following example, port 400 was incorrectly specified instead of port 443. What is the best way to correct this error?ITExamAnswers asked 2 years ago • CCNA 3 v7Which two packet filters could a network administrator use on an IPv4 extended ACL? (Choose two.)ITExamAnswers asked 4 years ago • CCNA 3 v7Consider the following output for an ACL that has been applied to a router via the access-class in command. What can a network administrator determine from the output that is shown?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v7What wildcard mask will match network 10.10.100.64/26?ITExamAnswers asked 2 years ago • CCNA 3 v7Which statement describes a characteristic of standard IPv4 ACLs?ITExamAnswers asked 4 years ago • CCNA 3 v7What type of ACL offers increased flexibility and control over network traffic?ITExamAnswers asked 2 years ago • CCNA 3 v7What wildcard mask will match networks 10.16.0.0 through 10.19.0.0?ITExamAnswers asked 2 years ago • CCNA 3 v7Which two statement describes a difference between the operation of inbound and outbound ACLs? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v7Which two characteristics are shared by standard and extended ACLs? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v7Which three statements are best practices related to placement of ACLs? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v7Which three statements describe how an ACL processes packets? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v7What two functions describe uses of access control lists? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v7