IT Questions Bank To what type of address are ICMPv6 neighbor solicitation messages sent?ITExamAnswers asked 2 years ago • CCNA 1 v7Which two ICMPv6 messages are used in to determine the MAC address of a known IPv6 address?ITExamAnswers asked 2 years ago • CCNA 1 v7Which two ICMPv6 messages are used in SLAAC?ITExamAnswers asked 2 years ago • CCNA 1 v7What is an attack using ARP?ITExamAnswers asked 2 years ago • CCNA 1 v7Which command could be used on a Cisco router to view its ARP table?ITExamAnswers asked 2 years ago • CCNA 1 v7Which statement is true about ARP?ITExamAnswers asked 2 years ago • CCNA 1 v7Where is the ARP table stored on a device?ITExamAnswers asked 2 years ago • CCNA 1 v7What two functions are provided by ARP? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 1 v7What two protocols are used to determine the MAC address of a known destination device IP address (IPv4 and IPv6)?ITExamAnswers asked 2 years ago • CCNA 1 v7What destination MAC address would be included in a frame sent from a source device to a destination device on a remote local network?ITExamAnswers asked 2 years ago • CCNA 1 v7What destination MAC address would be included in a frame sent from a source device to a destination device on the same local network?ITExamAnswers asked 2 years ago • CCNA 1 v7True or False? A router can be configured with a combination of both static routes and a dynamic routing protocol.ITExamAnswers asked 2 years ago • CCNA 1 v7Which is a characteristic of static routes?ITExamAnswers asked 2 years ago • CCNA 1 v7This type of route is also known as a gateway of last resort.ITExamAnswers asked 2 years ago • CCNA 1 v7What does a code of “O” indicate next to a route in the routing table?ITExamAnswers asked 2 years ago • CCNA 1 v7