CCNP TSHOOT Chapter 10 Test Online (Version 7) – Score 100%

Refer to the exhibit. A network administrator is replacing an existing router and configuring EIGRP authentication on the Serial 0/0/0 port. When viewing the routing table, the administrator notices that the entries for the remote networks are not listed. The administrator enters the debug eigrp packet command and notices this output:R1# *Nov 17 01:26:31.935: EIGRP: Serial0/0/0: ignored packet from 172.20.1.2, opcode = 5 (authentication off or key-chain missing)Based on the information in the running configuration and the output from the debug command, what is a possible reason for the missing routes?

Refer to the exhibit. After a major network upgrade, network users complain about poor video application performance. A network administrator verifies that all trunk links are up and operational and the EtherChannel configuration is correct. The output of the show interfaces port-channel command reveals that there is a 0 packet output rate over the last 5 minutes on the Po2 uplink. What could be done to correct the issue?

Which feature serves to offset the lack of authentication available with IEEE 802.1D Spanning Tree Protocol?

Which CLI commands will enable OSPFv3 authentication? (Choose two.)

Which LSA type is used to advertise external routes in OSPFv3?

Which IP address is used as destination IP address for Hello messages when OSPFv3 is used to transfer IPv4 routes?

Which command enables you to display IPv6 – MAC mappings on the router?

How can you include an interface into an OSPFv3 process for IPv4 address family?

Which command enables you to display the IPv6 BGP table?

How do you configure a specific interface for EIGRP in IPv6?

Which two features apply to MSTP? (Choose two.)

A router is currently running both OSPF and BGP. The administrator issues the command show ip route | exclude ^B. What routes will be displayed?

Refer to the exhibit. Which two conclusions can be made based on the output of the show mac address-table command?(Choose two.)

Refer to the exhibit. A network administrator is unable to ping between two workstations, PC1 and PC2, that are connected to switch3548. PC1 is connected to port Fa0/23, and PC2 is connected to port Gi0/2. Given the output of the show vlan command, which statement is true?

Refer to the exhibit. A forwarding loop has been created between switches A, B, and D. Given the output generated by the show spanning-tree vlan command on switches B and D, what could be the cause of the problem?

Which three types of ports or interfaces can be affected by the Spanning Tree Protocol? (Choose three.)

A network administrator is troubleshooting a connectivity issue in a Layer 2 switched network. After issuing the show macaddresstable command on the access switch, the administrator observes that there is no entry for the host that is experiencing the problems. The host machine is powered on and appears to be functioning normally. What can be deduced from this?

A network administrator types the following command on a router:R1# show ip ospf interface | include is up|CostWhich response would most likely be displayed after issuing this command?

A switch console displays the message %SPANTREE2CHNL_MISCFG. What does this mean?

Which IPv6 address is used by OSPFv3 as a next hop?