IT Exam Items Repository

Refer to the exhibit. A network administrator is utilizing RIPv1 in the exhibited network topology. What would the router R2 do with a packet that is originating from the 192.168.4.0/24 network and destined for network 172.16.1.0/24?
ITExamAnswers Editorial Team asked 6 years ago • 
A new chief information officer (CIO) has requested implementation of a link-state dynamic routing protocol. Which two routing protocols fulfill this requirement? (Choose two.)
ITExamAnswers Editorial Team asked 6 years ago • 
When a range of ports is being configured for EtherChannel, which mode will configure LACP on a port only if the port receives LACP packets from another device?
ITExamAnswers Editorial Team asked 6 years ago • 
When EtherChannel is implemented, multiple physical interfaces are bundled into which type of logical connection?
ITExamAnswers Editorial Team asked 6 years ago • 
What are two advantages of EtherChannel? (Choose two.)
ITExamAnswers Editorial Team asked 7 years ago • 
Refer to the exhibit. Which switching technology would allow data to be transmitted over each access layer switch link and prevent the port from being blocked by spanning tree due to the redundant link?
ITExamAnswers Editorial Team asked 6 years ago • 
Refer to the exhibit. A network administrator is verifying the bridge ID and the status of this switch in the STP election. Which statement is correct based on the command output?
ITExam Editorial Team asked 6 years ago • ,
Which industry-wide specification was developed to decrease the time that is needed to move to the forwarding state by switch ports that are operating in a redundantly switched topology?
ITExamAnswers Editorial Team asked 6 years ago • 
Which spanning tree standard was developed by Cisco to provide separate instances of 802.1w per VLAN?
ITExamAnswers Editorial Team asked 6 years ago • 
Refer to the exhibit. What is the role of the SW3 switch?
ITExamAnswers Editorial Team asked 6 years ago • 
Refer to the exhibit. The configuration shows the commands entered by a network administrator for inter-VLAN routing. However, host PCA cannot communicate with PCB. Which part of the inter-VLAN configuration causes the problem?
ITExamAnswers Editorial Team asked 6 years ago • 
A network administrator is adding a new VLAN for testing. The company uses VTP and the VLAN is not directly attached to either of the switches configured as VTP servers. What is the best method to add this VLAN to the network?
ITExamAnswers Editorial Team asked 6 years ago • 
A switched network has converged completely. All switches currently have a VTP revision number of 5. A new switch that has been configured as a VTP server is added to the network. The new switch has a VTP revision number of 4. What will occur within the network?
ITExamAnswers Editorial Team asked 6 years ago • 
A network engineer is interested in obtaining specific information relevant to the operation of both distribution and access layer Cisco devices. Which command provides common information relevant to both types of devices?
ITExamAnswers Editorial Team asked 6 years ago • 
In the Cisco hierarchical design model, which layer is more likely to have a fixed configuration switch than the other layers?
ITExamAnswers Editorial Team asked 6 years ago • 
« Previous1…125126127128129…1,378Next »
Ask Question