IP OSPF Network Nonbroadcast Command on CISCO Router/Switch

Command

IP OSPF Network Nonbroadcast

Use

This command manually sets the OSPF network type to nonbroadcast. This is a default for frame-relay and ATM links. Neighbor statements are required to form adjacency.
The Nonbroadcast network type has a DR election.

Syntax

Router(config-if)#ip ospf network nonbroadcast

Example

In this example, we will configure R4 to use its default network type. First we’ll configure OSPF on R1, R3, and R4 for all interfaces.

R4(config-router)#router ospf 1
R4(config-router)#network 0.0.0.0 0.0.0.0 area 0

Next we’ll configure the frame-relay network to use its default nonbroadcast type.

R4(config)#int s0/0
R4(config-if)#ip ospf network nonbroadcast

After a couple minutes, R4 still doesn’t have any adjacencies

R4(config-router)#do show ip ospf neighbor

R4(config-router)#

Notice that the OSPF network type is non_broadcast, so it will require unicast updates.

R4(config)#do show ip ospf interface s0/0
Serial0/0 is up, line protocol is up
Internet Address 10.4.4.4/24, Area 0
Process ID 1, Router ID 4.5.5.5, Network Type NON_BROADCAST, Cost: 64
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 4.5.5.5, Interface address 10.4.4.4
No backup designated router on this network
Timer intervals configured, Hello 30, Dead 120, Wait 120, Retransmit 5
oob-resync timeout 120
Hello due in 00:00:25
Supports Link-local Signaling (LLS)
Index 1/1, flood queue length 0
Next 0x0(0)/0x0(0)
Last flood scan length is 0, maximum is 0
Last flood scan time is 0 msec, maximum is 0 msec
Neighbor Count is 0, Adjacent neighbor count is 0
Suppress hello for 0 neighbor(s)

After we configure the neighbor statement, the adjacencies come up.

R4(config)#router ospf 1
R4(config-router)#neighbor 10.4.4.1
R4(config-router)#neighbor 10.4.4.3

R4(config-router)#
*Mar 1 00:45:55.347: %OSPF-5-ADJCHG: Process 1, Nbr 133.133.133.133 on Serial0/0 from LOADING to FULL, Loading Done
*Mar 1 00:45:55.359: %OSPF-5-ADJCHG: Process 1, Nbr 111.111.111.111 on Serial0/0 from LOADING to FULL, Loading Done

Related Articles

Leave a Reply

avatar