IT Exam Items Repository

When implementing RSTP, what is the designation for a port on a nonroot switch that blocks the port from forwarding?
ITExamAnswers Editorial Team asked 3 years ago • 
For the multiple tests that are required to complete a LAN design test plan, which action should be taken as a component of every test?
ITExamAnswers Editorial Team asked 3 years ago • 
A network designer must provide a rationale to a customer for a design which will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.)
ITExamAnswers Editorial Team asked 6 years ago • , ,
When a switch port is recovering from a failure, which protocol allows the port to transition directly to the forwarding state?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. After all the interfaces have stabilized, what is the spanning-tree state of all the enabled interfaces of SW11?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. A network technician is performing an initial installation of a new switch in the east wing. The technician removes the switch from the box, makes the connections to the network, and adds the configuration shown. The technician notifies the network administrator that the switch has been installed. When the network administrator at the home office attempts to telnet to the switch from host 192.168.0.1, the connection fails. What action should the network technician take?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. Why are interfaces Fa0/11, Fa0/23, and Fa0/24 not shown in this switch output?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. A network administrator has been given the task of creating a design for a temporary classroom building that is to be set up outside an overcrowded school. In testing the prototype, it is found that the student PC cannot ping the teacher PC. All the switch interfaces are active and connected properly, as is interface Fa0/0 of the router. Given that only the commands shown have bee added to the router configuration, what is the source of the problem?
ITExamAnswers Editorial Team asked 3 years ago • 
Why is it important to record baseline measurements of a prototype network?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. What two measures can be taken to address the areas of weakness circled in the network design? (Choose two.)
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. The users on the 192.168.10.192 network are not allowed Internet access. The network design calls for an extended ACL to be developed and tested. Where should the ACL be placed for the least effect on other network traffic?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. In the router command encapsulation dot1q 10, what does the number 10 represent?
ITExamAnswers Editorial Team asked 3 years ago • 
A network designer needs to determine if a proposed IP addressing scheme allows efficient route summarization and provides the appropriate amount of scalability to a design. What is useful for validating a proposed hierarchical IP addressing scheme?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. The redundant paths are of equal bandwidth and EIGRP is the routing protocol in use. Which statement describes the data flow from Server to PC2?
ITExamAnswers Editorial Team asked 3 years ago • 
Switch port Fa0/24 was previously configured as a trunk, but now it is to be used to connect a host to the network. How should the network administrator reconfigure switch port Fa0/24?
ITExam Editorial Team asked 5 years ago • ,
« Previous1…326327328329330…1,378Next »
Ask Question