IT Exam Items Repository Which option shows a correctly configured IPv4 default static route?ITExamAnswers Editorial Team asked 7 years ago • CCNA 2 v5Which of the following are three characteristics of a static route? (Choose three.)ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5A router-on-a-stick configuration will not allow PC1 on VLAN 10 to communicate with PC2 on VLAN 11. Which two of the following could be the problem? (Choose two.)ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5What command would be used to determine if all SVIs were “up and up” on a multilayer switch?ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5How many physical interfaces are required to perform inter-VLAN routing with each method indicated?ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5A network technician is configuring a router to support inter-VLAN routing. After entering interface G0/0 configuration mode, the network administrator attempts to enter the command encapsulation dot1q 10. The router refuses to accept this command. What could account for this failure?ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Which three options are valid inter-VLAN routing methods? (Choose three.)ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5What are three advantages of having a single trunk link on a switch and subinterfaces on the router instead of individual VLAN links between a switch that has three VLANs and a router to route between the VLANs? (Choose three.)ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Classify each item as either router-on-a-stick, Layer 3 switch routing, or both.ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Classify each item as either physical interface or subinterface.ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5The output of the show ip route command contains the following entry: S 10.2.0.0 [1/0] via 172.16.2.2. What value is indicated by the 1 in the [1/0] portion of the output?ITExamAnswers Editorial Team asked 5 years ago • CCNA, CCNA 2 v5What code is used in the routing table to identify routes learned through EIGRP?ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Refer to the exhibit. What is the purpose of the router port that is shown?ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5What is a Gateway of Last Resort?ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Which two statements describe characteristics of load balancing? (Choose two.)ITExamAnswers Editorial Team asked 6 years ago • CCNP, CCNA 2 v4, CCNA 2 v5