IT Exam Items Repository When a router learns that multiple paths are available to a destination network from the same routing protocol, which factor is considered by a router to choose the best path to forward a packet?ITExamAnswers Editorial Team asked 5 years ago • CCNA, CCNA 2 v5During the process of encapsulation, how does the PC determine if the packet is destined for a host on a remote network?ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5What address and prefix length is used when configuring an IPv6 default static route?ITExam Editorial Team asked 6 years ago • CCNA, CCNA 2 v5Which three statements describe features of Cisco devices that perform routing? (Choose three.)ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Which two design considerations are best practices for switch VLAN design? (Choose two.)ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Which Layer 2 security issue sends a frame destined for one VLAN to a different VLAN by adding more than one VLAN ID to the header?ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5The IEEE 802.1Q protocol is an industry standard for trunking.ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Match the problem definition with the correct problem description.ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Match the commands with the correct descriptions.ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Which three options accurately associate the Catalyst switch command with the result? (Choose three.)ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Refer to the following configuration. Host 1 is connected to interface Fa0/4 with IP address 192.168.1.22/28. Host 2 is connected to interface Fa0/5 with IP address 192.168.1.33/28. Host 3 is connected to interface F0/6 with IP address 192.168.1.30/28. Select the three statements that describe the success of pinging from one host to another. (Choose three.)ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5With each listed characteristic on the right, indicate in the blank on the left whether it reflects a normal range VLAN, an extended range VLAN, or VLAN 1. Use N for normal range VLAN, E for extended range VLAN, and 1 for VLAN 1.ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Refer to the exhibit. Host PC3 is unable to transfer data because it does not have the MAC address of the destination host. If PC3 sends out an ARP request broadcast, which of the other hosts will see the message?ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5Which three statements are true about hosts that are configured in the same VLAN? (Choose three.)ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5What are two options to consider when configuring a trunk link between two switches? (Choose two.)ITExamAnswers Editorial Team asked 3 years ago • CCNA 2 v5