IT Questions Bank What are two types of router interfaces? (Choose two.)ITExamAnswers asked 4 years agoWhich statement describes a hardware feature of a Cisco 1941 router that has the default hardware configuration?ITExamAnswers asked 4 years agoRefer to the exhibit. Which route from the PC1 routing table will be used to reach PC2?ITExamAnswers asked 4 years agoA network administrator issues the following commands on a Layer 3 switch: What is the administrator configuring?ITExamAnswers asked 4 years agoLaunch PT. Hide and Save PT. Open the PT Activity. Perform the tasks in the activity instruction and then answer the question. What destination address will PC1 include in the destination address field of the Ethernet frame that it sends to PC2?ITExamAnswers asked 4 years agoOpen the PT Activity. Perform the tasks in the activity instruction and then answer the question. What destination address will PC1 include in the destination address field of the Ethernet frame that it sends to PC2?ITExamAnswers asked 4 years agoWhat statement illustrates a drawback of the CSMA/CD access method?ITExamAnswers asked 4 years agoWhich address or combination of addresses does a Layer 3 switch use to make forwarding decisions?ITExamAnswers asked 4 years agoHow does adding an Ethernet line card affect the form factor of a switch?ITExamAnswers asked 4 years agoWhich two statements describe a fixed configuration Ethernet switch? (Choose two.)ITExamAnswers asked 4 years agoA Layer 2 switch is used to switch incoming frames from a 1000BASE-T port to a port connected to a 100Base-T network. Which method of memory buffering would work best for this task? answered 4 years ago • CCNAA network administrator is connecting two modern switches using a straight-through cable. The switches are new and have never been configured. Which three statements are correct about the final result of the connection? (Choose three.)ITExamAnswers asked 4 years ago • CCNAA host is trying to send a packet to a device on a remote LAN segment, but there are currently no mappings in its ARP cache. How will the device obtain a destination MAC address?IT Administrator asked 4 years agoWhich two statements are correct about MAC and IP addresses during data transmission if NAT is not involved? (Choose two.)ITExamAnswers asked 4 years agoWhat is the Layer 2 multicast MAC address that corresponds to the Layer 3 IPv4 multicast address 224.139.34.56?ITExamAnswers asked 4 years ago