IT Questions Bank Which command can be used to test connectivity between two computers that are attached to a network?ITExamAnswers asked 4 years agoMatch the icon to its likely associated use. (Not all options are used.)ITExamAnswers asked 4 years agoRefer to the exhibit. Match the port to the associated letter shown in the exhibit. (Not all options are used.)ITExamAnswers asked 4 years agoMatch the form of network communication with its description. (Not all options are used.)ITExamAnswers asked 4 years agoIf a technician uses an average of 2 cans of compressed air per week for cleaning, how many cans should be ordered for 8 technicians over the next 10 weeks?ITExamAnswers asked 4 years agoWhich two devices provide permanent data storage? (Choose two.)ITExamAnswers asked 4 years agoConsidering the average capacity of storage device media, drag the storage media on the left to the capacity list on the right.ITExamAnswers asked 4 years agoA local real estate company can have its 25 computer systems upgraded for $1000. If the company chooses only to upgrade 10 systems, how much will the upgrade cost if the same rate is used?ITExamAnswers asked 4 years agoThe failure rate in a certain brand of network interface card has been determined to be 15%. How many cards could be expected to fail in a company that has 80 of the cards installed?ITExamAnswers asked 4 years agoWhat is the subnet ID associated with the IPv6 address 2001:DA48:FC5:A4:3D1B::1/64?ITExamAnswers asked 4 years agoA network administrator is implementing DHCPv6 for the company. The administrator configures a router to send RA messages with M flag as 1 by using the interface command ipv6 nd managed-config-flag . What effect will this configuration have on the operation of the clients?IT Administrator asked 4 years agoRefer to the exhibit. A network administrator is troubleshooting a problem with EtherChannel. What command was used to produce the exhibited output?IT Administrator asked 4 years agoWhat is a potential issue when using the WLC to upgrade and deploy the latest firmware image to all APs?IT Administrator asked 4 years agoWhich command will start the process to bundle two physical interfaces to create an EtherChannel group via LACP?ITExamAnswers asked 4 years agoRefer to the exhibit. When a packet arrives on interface Serial0/0/0 on R1, with a destination IP address of PC1, which two events occur? (Choose two)IT Administrator asked 4 years ago