IT Questions Bank

IT Questions Bank 1

A network administrator is configuring an EtherChannel link between switches SW1 and SW2 by using the command SW1(config-if-range)# channel-group 1 mode auto . Which command must be used on SW2 to enable this EtherChannel?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which two parameters must match on the ports of two switches to create a PAgP EtherChannel between the switches? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago
What type of VLAN supports untagged traffic?
IT Questions Bank 2ITExamAnswers asked 4 years ago
What type of VLAN is designed to have a delay of less than 150 ms across the network?
IT Questions Bank 2ITExamAnswers asked 4 years ago
What type of VLAN is designed to reserve bandwidth to ensure IP Phone quality?
IT Questions Bank 2ITExamAnswers asked 4 years ago
What type of VLAN should not carry voice and network management traffic?
IT Questions Bank 2ITExamAnswers asked 4 years ago
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw> enable command?
IT Questions Bank 2ITExamAnswers asked 4 years ago
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw(config-if)# ipv6 address 2001:db8:a2b4:88::1/64 command?
IT Questions Bank 2ITExamAnswers asked 4 years ago
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw(config-if)# shutdown command?
IT Questions Bank 2ITExamAnswers asked 4 years ago
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw# configure terminal command?
IT Questions Bank 2ITExamAnswers asked 4 years ago
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw(config-if)# mdix auto command?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A network technician is troubleshooting an issue and needs to verify all of the IPv6 interface addresses on a router. What is the best command to use to accomplish the task?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A student wants to save a router configuration to NVRAM. What is the best command to use to accomplish the task?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Students who are connected to the same switch are having slower than normal response times. The administrator suspects a duplex setting issue. What is the best command to use to accomplish the task?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
An administrator decides to use “Elizabeth” as the password on a newly installed router. Which statement applies to the password choice?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
« Previous1…1,2921,2931,2941,2951,296…1,315Next »
Ask Question