IT Questions Bank Which feature is uniquely found in an access layer switch within a hierarchical network model?ITExamAnswers asked 2 years ago • CCNA 3 v4In which mode is a VTP switch operating if it has been configured to only forward VTP advertisements?ITExamAnswers asked 2 years ago • CCNA 3 v4How does a switch that is configured for 802.1Q trunking handle untagged frames that are received on a trunk port?ITExamAnswers asked 2 years ago • CCNA 3 v4Which method establishes an administrative connection for configuring the Linksys WRT300N wireless access point?ITExamAnswers asked 2 years ago • CCNA 3 v4What three tasks should be performed before moving a Catalyst switch to another VTP management domain? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v4What is the purpose of the switch command switchport access vlan 99?ITExamAnswers asked 2 years ago • CCNA 3 v4An administrator is troubleshooting a PC on the network which is suffering from slow and intermittent connectivity. The PC has a ping success rate to the default gateway of less than half the ping attempts. Other PCs on the switch can consistently ping the default gateway. The switch port is configured for auto duplex and the PC is configured for full duplex. What will commonly cause this problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Which value determines if a switch becomes the central point of reference in the spanning tree topology?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Router RA receives a packet with a source address of 192.168.1.65 and a destination address of 192.168.1.161. What will the router do with this packet?ITExamAnswers asked 2 years ago • CCNA 3 v4Which device must be installed in each computer to allow a wireless connection to be established?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Switches SW3 and SW4 are brand new switches with default configurations. The links between the switches are configured as trunk links and all VLANs are allowed on the trunks. On the basis of the show running-config output that is provided, which VLANs will be available on SW3 and SW4?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Computer A sends a broadcast message. Which devices will see the broadcast?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A wireless infrastructure has been established in a company building as shown. The design goal was to allow roaming between the three APs for handheld devices. However, the devices lose connectivity when the users roam. How can this problem be fixed?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Why must the NIC of host H1 operate in half-duplex mode?ITExamAnswers asked 2 years ago • CCNA 3 v4A network administrator is implementing a Layer 2 solution for a legacy network that uses a combination of switches. Many of the older devices support only ISL trunking while others support both ISL and 802.1Q trunking. Which STP variant would be best suited for this network?ITExamAnswers asked 2 years ago • CCNA 3 v4