Category: CCNA 2 v5 Answers

CCNA 2 Routing and Switching Essentials v5 Chapter 11: Network Address Translation for IPv4 – Check Your Understanding Questions Answers 1. Refer to the following output. Based on the output, which statement is true about the NAT configuration? Static NAT is configured. Dynamic NAT is configured. NAT Overload …

CCNA 2 Routing and Switching Essentials v5 Chapter 10: DHCP – Check Your Understanding Questions Answers 1. Which statements are true about the DHCP server functions? (Choose two.) When a client requests an IP address, the DHCP server searches the binding table for an entry that matches the …

CCNA 2 Routing and Switching Essentials v5 Chapter 9: Access Control Lists – Check Your Understanding Questions Answers 1. What range of IP addresses is represented by the network and wildcard mask 192.168.70.0 0.0.0.127? 192.168.70.0 to 192.168.70.127 192.168.70.0 to 192.168.70.255 192.168.70.0 to 192.168.70.63 192.168.70.0 to 192.168.71.255 2. What …

CCNA 2 Routing and Switching Essentials v5 Chapter 8: Single-Area OSPF – Check Your Understanding Questions Answers 1. What will an OSPF router prefer to use first as a router ID? Any IP address that is configured using the router-id command A loopback interface that is configured with …

CCNA 2 Routing and Switching Essentials v5 Chapter 7: Routing Dynamically – Check Your Understanding Questions Answers 1. What is the difference between interior and exterior routing protocols? Exterior routing protocols are used only by large ISPs. Interior routing protocols are used by small ISPs. Interior routing protocols …

CCNA 2 Routing and Switching Essentials v5 Chapter 6: Static Routing – Check Your Understanding Questions Answers 1. Which statement is true concerning configuring static routes using next-hop addresses? Routers cannot use more than one static route with a next-hop address. When the router identifies that a packet …

CCNA 2 Routing and Switching Essentials v5 Chapter 5: Inter-VLAN Routing – Check Your Understanding Questions Answers 1. Classify each item as either physical interface or subinterface. one physical interface for many VLANs bandwidth contention access mode switch port connection complex cable configuration trunk mode switch port connection …

CCNA 2 Routing and Switching Essentials v5 Chapter 4: Routing Concepts – Check Your Understanding Questions Answers 1. Which two statements correctly describe the components of a router? (Choose two.) RAM permanently stores the configuration file used during the boot sequence. ROM contains diagnostics executed on hardware modules. …

CCNA 2 Routing and Switching Essentials v5 Chapter 3: VLANs – Check Your Understanding Questions Answers 1. What is the difference between an access port and a trunk port? A trunk port belongs to a single VLAN; an access port provides access for multiple VLANs between switches. An …

CCNA 2 Routing and Switching Essentials v5 Chapter 2: Basic Switching Concepts and Configuration – Check Your Understanding Questions Answers 1. Which three options correctly associate the command with the paired behavior? (Choose three.) switchport port-security violation protect: Frames with unknown source addresses are dropped and a notification …