IT Exam Items Repository

On a Cisco router, which interface would be used to make the initial configuration?
ITExamAnswers Editorial Team asked 4 years ago • 
In a Cisco device, where is the IOS file stored prior to system startup?
ITExamAnswers Editorial Team asked 4 years ago • 
The connection between routers B and C has been successfully tested. However, after rebooting router C, the administrator noticed the response time between networks 10.10.3.0 and 10.10.4.0 is slower. Ping between the two routers is successful. A trace route indicates three hops from router B to router C. What else can be done to troubleshoot the problem?
ITExamAnswers Editorial Team asked 4 years ago • 
Which combination of keys would be used at the CLI prompt to interrupt a ping or traceroute process?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. A student is responsible for the IP addressing, configuration and connectivity testing of the network shown in the graphic. A ping from host B to host C results in a destination unreachable but a ping from host B to host A was successful. What two reasons could account for this failure based on the graphic and partial router output for the Dallas router? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • 
Which three terms correctly define the forms of help available within the Cisco IOS? (Choose three.)
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. What additional command is required to allow remote access to this switch?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. The output is shown for the show ip route command executed on Router A. What does the IP address 192.168.2.2 represent?
ITExamAnswers Editorial Team asked 4 years ago • 
What command is used to change the default router name to Fontana?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. Which names correctly identify the CLI mode represented by the prompt for Switch-East4#? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • 
Users in the network are experiencing slow response time when doing file transfers to a remote server. What command could be issued to determine if the router has experienced any input or output errors?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. A network administrator on HostA has problems accessing the FTP server. Layer three connectivity testing was successful from HostA to the S1 interface of RouterB. Which set of commands will allow the network administrator to telnet to RouterB and run debug commands?
ITExamAnswers Editorial Team asked 4 years ago • 
When network services fail, which port is most often used to access a router for management purposes?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. A technician applies the configuration in the exhibit to a clean router. To verify the configuration, the technician issues the show running-config command in the CLI session with the router. What lines should the technician expect to see in the router output from the show running-config command?
ITExamAnswers Editorial Team asked 4 years ago • 
In a Cisco router, when do changes made to the running-configuration take effect?
ITExamAnswers Editorial Team asked 4 years ago • 
« Previous1…781782783784785…1,378Next »