5.2.2.8 Packet Tracer – Troubleshooting Switch Port Security Instructions Answers

5.2.2.8 Packet Tracer – Troubleshooting Switch Port Security Instructions Answers
5 (1) vote

4

Packet Tracer – Troubleshooting Switch Port Security

Scenario

The employee who normally uses PC1 brought his laptop from home, disconnected PC1 and connected the laptop to the telecommunication outlet. After reminding him of the security policy that does not allow personal devices on the network, you now must reconnect PC1 and re-enable the port.

Requirements

· Disconnect Home Laptop and reconnect PC1 to the appropriate port.
– When PC1 was reconnected to the switch port, did the port status change? No
– Enter the command to view the port status. What is the state of the port?

S1#show interfaces fa0/1
FastEthernet0/1 is administratively down, line protocol is down (disabled)

– Which port security command enabled this feature?

S1(config-if)#switchport port-security violation shutdown

· Enable the port using the necessary command.

S1(config)#in fastEthernet 0/1
S1(config-if)#no shutdown

· Verify connectivity. PC1 should now be able to ping PC2.

Suggested Scoring Rubric

Packet Tracer scores 90 points. Answers to the questions are worth 10 points.



Related Articles


Leave a Reply

avatar